Examples of using Fast flashing in English and their translations into German
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Ecclesiastic
-
Political
-
Computer
-
Programming
-
Official/political
-
Political
Fast flashing of the light.
Modes: normal, slowly and fast flashing.
Fast Flashing indicator 2xper second.
Solid Flashing fast Flashing slow.
Fast flashing with a short break.
Continuous light, slow flashing and fast flashing.
Fast flashing Red Invalid operation Any.
Three settings including slow and fast flashing and constant.
Fast flashing Green Volume adjustment USB.
With the ALT key the user can get a fast flashing between PDF A/PDF B to highlight deviations.
Fast flashing Blue Volume adjustment Dock.
Press SET and immediately release it: the“1-2MOT” LED starts to flash indicating the currently selected setting:-Slow flashing 1-motor operations;- Fast flashing 2-motor operations.
Fast flashing Orange Volume adjustment Aux.
Slow blinking, fast flashing andcontinuous light.
Fast flashing Red Volume at minimum or maximum.
This is shown by a fast flashing of the indications of the charging status 4.
Fast flashing purple Volume adjustment AirPlay.
Slow flashing Teach mode Fast flashing Reset One long, x-short depends on the type of error.
Fast flashing: unit is running on starting cycle.
Zone abnormal OFF Zone normal Fast flashing Zone was or still is in alarm mode Fast flashing, 3x with stopping interval.
Fast flashing: data transmission blocked fifo full.
Fast flashing: SD-Card not inserted/ SD-Card capacity is reached/ SD.
Fast flashing(1sec): the system is searching to pair up to a telephone.
Red Fast Flashing: The battery power is depleted and the unit will soon shut down.
Fast flashing of the display illumination showing an error message means an current failure is reported.
Fast flashing of the"programme phases" and DOOR LOCKED indicator lights indicate an anomaly see“Troubleshooting”.
Fast flashing: no wireless communication dead battery, probable radio frequency interference, possible problem with relevant sensor.
Fast flashing for a short time(the decoder is copying the reset values from Flash to EEPROM), succeeded by error code 5 since there is now no valid address in EEPROM.
Fast flashing of the display illumination showing JB-Lighting means a failure was reported and stored in the ERROR LIST To clear- see menu navigation.
Fast flashing of the display illumination showing means a failure was reported and stored in the ERROR LIST To clear- see menu navigation on page 24.