Examples of using Indenter in English and their translations into German
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Ecclesiastic
-
Political
-
Computer
-
Programming
-
Official/political
-
Political
Micro hardness for one indenter position.
An indenter specifically for the Lisp scripting language and Lisp dialects.
Friction between surface and indenter.
The combination of indenter and test force make up the Rockwell scale.
Brinell and Vickers test methods, just replace indenter to do specific testing.
Indenter can be tailored to customer requirements over a wide range.
Collision Resistant System- prevents indenter or objective damage.
Nose-mounted indenter enables testing at difficult-to-access measurement points.
Complete field animation of any contact(indenter-, scratch- or groove-) tests.
Nose-mounted indenter allows hardness testing in difficult-to-access measuring points.
Minimal resetting when changing between methods or changing indenter and sensor foot.
Pharr's effective indenter" for layered materials and curved surfaces.
Determination of hardness andYoungs modulus of thin layers by Nanoindentation Nano Indenter XP; MTS.
Hosts including Vickers indenter one set, 10X, 20X objective of each one.
Example: HR 30 N xx Rockwell hardness xx measured under a load of 294.2 N(30 kgf)with a conical diamond indenter.
If needed, the IRHD M or IRHD N indenter can be exchanged by customer easily.
The greater the hardness of the material to be tested, the smaller theindention depth; but the higher the indenter load.
For the first time in hardness testing the indenter adapts itself fully automatically parallel to the contour during the test cycle.
Standard delivery comes with 5x and 10x objectives, all of them can do measurement, indenter and objective switches motorized.
The deeper the indenter penetrates into the sample material at a given load and with a given indenter, the softer the material is.
From 2011 to 2013, samples were first measured ex situ;the first measurements with the indenter in the beam began at the end of 2013.
The most common indenter type is a diamond cone ground at 120 degrees for testing hardened steels and carbides.
However, differential frequency is also dependent on the elastic property(e-module, Poisson's ratio)of the resonator, indenter and test materials.
Moreover, the indenter is fully protected from collision by the reference ring and the exchange of a measuring tip can be done in less than 2 minutes.
In Rockwell hardness testing, the hardness of a material is determined by pressing an indenter against the material be tested with a predefined force.
The indenter is the same for both ranges therefore Vickers hardness values are continuous over the total range of hardness for metals typically HV100 to HV1000.
The supporting shoulder and the surface that the specimen sits on must be parallel to each other,and the anvil must present the test specimen perpendicular to the indenter.
The indenter(diamond cone or hardmetal ball) is pressed into the sample in two steps with a preliminary test force, which determines the starting point of the indentation depth, and the additional test force.
Micro or Macro hardness testing, also commonly referred to as Knoop or Vickers testing,is also performed by pressing an indenter of specified geometry into the test surface.
Naturally, information shares of the whole measurementinformation of an indentation measurement allocate to the instrument, indenter, coating(s), substrate and- if present- interlayers etc.