Examples of using Midi cable in English and their translations into German
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Ecclesiastic
-
Political
-
Computer
-
Programming
-
Official/political
-
Political
Roland MIDI cable 6 meters length.
The application has 8 virtual Midi cables.
Midi cable 6 m, metal diode plugs- black.
Conveniently integrated USB and MIDI cables.
The Klotz MID-030 MIDI cable does not miss a single detail.
Exchi3 send and receive KORG i2/i3 files through MIDI cable.
Owner's Manual, MIDI cable, USB cable, adapter.
MIDI Cables With two 5-pole DIN plugs(180°), in different lengths.
Make sure that all MIDI cables are correctly connected.
No MIDI cables, no installation, just free-flowing sync that works.
Commercially available MIDI cables are used to transfer MIDI data.
When using an external MIDI source to control the amplifier,a five-pin MIDI cable can be used.
Make sure that the MIDI cable is connected correctly p.20.
The Butcher can also be controlled remotely via MIDI using a standard five-pin MIDI cable.
The pedal can be phantom powered by MIDI cable or a 9v power supply not included.
In the middle, there is the MIDI I/O,please connect your keyboard here with a standard MIDI cable.
This USB 2.0 to Midi cable by Delock enables you to connect Midi devices, e.g. home stereo, keyboard etc.
Connect the[MIDI OUT] terminal tothe external MIDI sequencer's MIDI IN terminal using a commercially available MIDI cable.
Connect the MIDI source to the Obey with a 5 pin MIDI cable, and the Obey 40 D-Fi 2.4 will respond to MIDI input.
Use a MIDI cable to connect the HT-70's MIDI OUT connector to your externalMIDI device's MIDI IN connector.
A durable cable set consists of instrument cables, MIDI cables, USB cables, jack adapter and a power adapter, for example.
Connect a MIDI cable to the LP-380's MIDI IN connector and to the MIDI OUT connector of a sequencer or other MIDI device.
The USB connection allows you to use the KP3 as a USB-MIDI device that transmits andreceives MIDI messages without having to connect the MIDI cables.
While most MIDI connections still use strictly MIDI cables, some setups only require a USB to USB connection, or USB to MIDI depending on your gear or MIDI interface situation.
It consists of the transmitter(that is external or into harmonika built) and the receiver,which are attached to the sound module with a MIDI cable, bungee cords, key board, or the computer.
Connect the MIDI Out port, located on the left hand side of your controller, to the MIDI Portlabeled"IN" on the MIDI device that you wish to control, using a standard MIDI cable.
And the best of it: Because MIDI is an established standard, every common computer OS could handle it. To start You would only need a simple sound card,an input device(standard sized keyboard recommended), MIDI cables, and, depending on the sound card, an external tone generator.
Should a problem arise and the Jockey 3‘s LEDs are not lit correctly, in most cases this is probably caused by installed MIDI software e.g. MidiYoke,Maple Virtual MIDI Cable, OSCulator, Bome Midi Translator etc.
Because these connections are virtual,there is no need for messy audio or MIDI cabling.