Examples of using Setscrews in English and their translations into German
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Ecclesiastic
-
Political
-
Computer
-
Programming
-
Official/political
-
Political
Suitable for wood, chipboard and setscrews.
Black housing and setscrews for attractive appearance.
Q Bobbin holder w Stoppere Knob r Screwdriver t Setscrews.
Justable baseground with setscrews and air lever Libelle.
Setscrews for adjusting the mechanical focus setting for the lens 9.
A preadjustment stage of bubble levels and setscrews is not necessary.
Setscrews, tightened with Allen wrench, for easy installation.
Cutters with Weldon shank must be fastened with two setscrews(DIN 913) on.
By removing the setscrews(1), the footrest can be adjusted to fit any lower leg length.
Microscope stages are employed in high-precision microscopes, where they are positioned using setscrews, amongst others.
Setscrews on the bottom allow for fixing the extractable side parts.
Shock-free operation as well as the retrievability of positions(using scales at the stage or stops at the setscrews) is given top priority.
By removing the setscrews(1), the footrest can be adjusted to fit any lower leg length.
The GYA-RRB series of relubricatable andnon-relubricatable bearings offer an extended inner ring with specially designed setscrews to lock on shafting.
Loosen the two silver setscrews on the focuser and pull out the small plastic dust cap.
The GY-KRRB series of relubricatable andnon-relubricatable bearings offer a full-width inner ring with specially designed setscrews to lock on shafting.
If necessary, loosen the setscrews(3) of the base and the camera support, using the hex key supplied.
Just slide the assembly onto your keyed shaft,secure it with the torque pin and setscrews, and you are ready to apply air and run.
Setscrews; for panning the camera around the axis of the lens release the screws and then retighten them 11.
Setscrew locking housedunits are equipped with two specially designed setscrews positioned at a 90-degree angle in an inner ring that locks onto the shaft.
By turning both setscrews[3-7] counterclockwise, the 45 limit position can be increased to a maximum of 47.
Just slide the assembly onto your keyed shaft,secure it with the torque pin and setscrews, install friction modules, and you are ready to apply air and run.
Apply threadlock on the setscrews, then tighten the setscrew on the fl at ares using a 1.5mm hex wrench.
Our newly developed clip housing with setscrews reduce the overall height by as much as 15 mm compared with conventional strap clips.
