Examples of using Switch setting in English and their translations into German
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Ecclesiastic
-
Political
-
Computer
-
Programming
-
Official/political
-
Political
DIP switch setting for built-in terminator.
Bring the main switch(12) in the switch setting.
Switch setting for grilling over water bath.
Switch setting for grilling over lava stones.
The wiring method and switch setting are different in each case.
Switch setting PDM because of synchronous transmission.
Special features manual/automatic operation, switch setting readable.
The Computer Switch Setting dialog box will appear.
Refer to the following table for the relationship between the switch setting and the rotating speed.
Switch setting PDM as for all pulse width measurements.
Bring the main switch(11) in the switch setting to the“SETUP” mode.
However, this switch setting can also simply be used as a matter of taste.
A For load distribution in parallel operation,the devices can be switched from single mode(switch setting OFF) to parallel mode switch setting ON.
SW2 switch setting All switches are factory-preset to OFF position.
With 6 speed settings and a pulse switch setting of this masterpiece is completed.
SW4 switch setting Both switches are factory-preset to ON position.
The product is effectively protected against UV light,which prevents rapid gumming in sunlight and hence an increase of switch setting forces.
In the“0“ switch setting, the socket can be used for an extension line e.g. for a light.
Example: Here, you can see the switch setting for the MAC address 42 and the bitrate 500 kBit/s.
Switch setting Amplification of the analogue input signal(Line In/Micro In) 0 0 dB(no amplification) 1 3 dB 2 6 dB 3 9 dB 4 12 dB 5 15 dB 6 18 dB 7 21 dB 8 24 dB(maximum amplification) 9 24 dB maximum amplification.
Their shift strategy in the switch setting Ds, is the result of close consultation with fire service users.
Dip Switch Setting: Jumbo Frame Support up to 9.6k, port-isolation between the RJ45-Ports and FX 100M or FX 1000M.
Smart Cord, QD on RJ9, smooth 0,8 meters, switch setting 1-8 for all standard telephones, for headsets with STD variant, Compliance with the EU Noise Directive.
B In switch setting OFF(constant current mode), the device supplies a constant current of about 1.15 x rated current in the case of an.
To determine the soil moisture: Switch setting"MOIST"Insert the two probes into the soil between the edge and the centre of the pot to a depth of up to about 3/4 of the probe length.
Figure 5: Switch setting and wiring for room control using external separate sensor and TG-R430 as setpoint.
It has a switch setting that is designed for operating the heating function without the boiler having been filled.
Figure 6: Switch setting and wiring using external, separate sensor and potentiometer TBI-xx as setpoint.
The camera memorizes the lighting color temperature at the time when the switch setting is changed from ON to OFF, and the camera color is adjusted to the memorized color temperature.(AWC) If the lighting color temperature is changed and you want to make the camera be memorized/operated with the changed color temperature, re-operate the switch On/Off operation.