Examples of using Timer display in English and their translations into German
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Ecclesiastic
-
Political
-
Computer
-
Programming
-
Official/political
-
Political
Timer display To show the time in minutes.
The decimal dot on the timer display flashes.
Timer display- shows the selected cycle time 3.
Touch the 3 symbol,‹‹ lights up in the timer display.
The timer display starts blinking indicating that the time has to be selected 3.
Touch the 0 symbol to show the timer display again.
For 6 seconds the timer display remains at“0“ before it will be switched-off.
The operation time is shown on the timer display.
The timer display always shows the timer for the selected zone or the shortest timer. .
When the time is over, a signal sounds and the timer display blinks.
The timer display will show the remaining time of the next zone which will switch off.
Press the«OVEN/ TIMER» button to select the timer display default 0.
The timer display 4 shows“00” and the indicator 5 relative to the zone being programmed lights up.
After the time has elapsed, you will hear a beep.‹‹ lights up in the timer display.
Touch timer control. is shown in the timer display where touched. flashes.
When the cooking time has elapsed After the time has elapsed, you hear an audible signal.‹‹ lights up in the timer display.
The indicator displays the remaining time and the timer display flashes for 5 seconds.
The timer display shows 0.00 to indicate that the timer for the selected burner is not active.
When the time is over there is a sound signal and the timer display blinks.
A beep sounds, the timer display shows a“00” and the cooking zone displays show a“t” blinking indicating that a cooking zone has to be selected.
When the timer has run down, a signal sounds and the timer display shows"00" statically, the.
While in rain delay mode, the timer display will switch between the actual time and the remaining hours of the delay, every 2 seconds.
The and‚ symbols flash alternately in theheat setting display and‹ appears in the timer display as a default setting.
If both burners are programmed at the same time, the timer display will show the count for the burner that will switch off first and the Led related to this burner will flash faster than the other one.
As soon as the timer is selected the according LED is blinking and the dot in the timer display is flashing permanently.
Fi rst the temperature display fl ashes‘Strt' and the timer display shows the energy used by last cooking process.
As soon as the timer has been selected, the assigned timer- LED 2 blinks and the dot in the timer display 3 glows.
When the time set on the timer haselapsed the timed heater is switched off, the timer display and the timed heater led starts blinking and a timer alarm beep sounds for one minute.
These indicate for which cooking zone the timer has been activated.· As soon as the timer has been selected,the assigned timer-LED blinks and the dot in the timer display glows.
The turning on of the burner is also indicated by the relative LED near the timer display, which will be on for the entire time that the burner is on.