Examples of using Host controller in English and their translations into Greek
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Financial
-
Official/political
-
Computer
You need a host controller for USB.
Repeat that process for any remaining USB Host Controller.
The host controller does not recognize the device removal.
The key words are USB Host Controller.
This leaves the host controller or device in a hung state.
Supported devices:"Intel(R) USB 3.0 eXtensible Host Controller".
The USB host controller uses the periodic scheduler for USB 2.0 devices.
CAUSE AMD has identified an issue with the host controller.
Host Controller working with the frequency three-phase motor to control transmission.
Locate and then double-click USB2 Enhanced Host Controller.
Expand each USB universal host controller node, and then expand successive subnodes until you find the name of the USB device.
The USB 2.0 HCD implementation is called the Enhanced Host Controller Interface(EHCI).
When the computer sets the 1394 host controller to a high power(D0) state, the host controller may generate an incorrect PCI-Express packet.
The Windows XP USB user interface does not support more than 10 host controllers.
Note This setting affects all USB host controller drivers in the system.
One hub is known as the root hub which is built into the host controller.
Note Typically, a USB 2.0 Enhanced(EHCI) host controller will disable the periodic schedule if there are no periodic transfers scheduled, which helps to reduce power consumption by the host controller.
The bandwidth reporting user interface is not supported on high-speed host controllers.
If the USB device generates resume signaling during this time, the host controller, the USB device, or both may end up in a state where it can no longer detect and trigger the wakeup of the computer.
There always exists one hub known as the root hub,which is built into the host controller.
If there are any references to USB,such as USB Host Controller, right-click the name, select Update Driver Software, and then follow the on-screen instructions to download and install any available updates.
There always exists one hub known as the root hub,which is attached directly to the host controller.
After you install this update,if you add a host controller for a new 1394 device to your computer, you must add or modify the SidSpeed entry in the Windows registry for the new 1394 host controller.
This typically occurs when devices that rely on the periodic scheduler are attached to the host controller.
In some situations, such as when a device that does not support USB Selective Suspend is attached to a USB host controller with this configuration, this might increase the power consumption of the system by approximately 5 percent.
For example, this issue may occur if the USB device uses the periodic schedule on the USB host controller.
When a STALL occurs while there is significant additional traffic on the bus,the USB 2.0 host controller driver(Usbehci. sys) may not return the correct result status for a USB transfer that has been stopped because of a STALL condition.
This typically occurs when devices are removed from a nested USB hub that is attached to the host controller.
Most of PCI-based EHCI controllers contain other HCD implementations called'companion host controller' to support Full Speed and Low Speed devices.
These STALL packets are typically issued by the device in response to a command that the host controller cannot run successfully.