Examples of using Reference voltage in English and their translations into Greek
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Financial
-
Official/political
-
Computer
Accuracy Reference Voltage(V).
Reference voltage ratio 220v.
Selectable internal or external reference voltage.
The reference voltage selection(internal or external) can be verified via the SPI interface.
Bit A/D converter with 8 multiplexed reference voltages.
If you need different reference voltage or current specification, please advisory our sales personnel.
Single-phase measurement can also be measured to support the B-phase ground PT secondary voltage as a reference voltage;
A logarithmic voltage ratio with a reference voltage of V0= 1.0000 volt≡ 0 dBV.
The devices are available in fi xed output voltages of 1.5V,1.8V, 2.5V, 3.3V and as an adjustable device with a 1.21V reference voltage.
A logarithmic voltage ratio with a reference voltage of V0= 0.7746 volt≡ 0 dBu.
Actually, it is smaller than R5 to compensate for IC2's internal voltage divider which is connected in parallel with the reference voltage source in IC2.
Measuring the metal oxide arrester DC reference voltage and 0.75 times the DC reference voltage leakage current;
The P1 must be set to provide 158 mV(5.0 V/ 31.62), on pin 6 of IC1, that is, -30 dB relative to the reference voltage on pins 7 and 8 of IC2.
One wire carries a varying voltage that represents the signal,while the other wire is connected to a reference voltage, usually ground.
When the measured phase and the reference voltage are not At the same time, the compensation angle can be calculated automatically.
R5 is used to adjust the current in each LED on IC2 while network R5-R6-P1-R7 sets the reference voltage that determines the full-scale input signal level for IC2.
Defluction: When 115% reference voltage and no current in current circuit, no more than 1 pulse can be made by meter.
It is sometimes used to set an external reference voltage(between 0 and 5 volts) as the upper limit for the analog input pins.
The tester relies on the voltage reference signal,collects the reference voltage and the lightning arrester leakage current at high speed, and performs fast Fourier transform through the harmonic analysis method to calculate the resistive component(fundamental wave, harmonic) and capacitive component respectively.
Built-in 3.3V regulator is a reliable reference voltage, and can operate reliably, requires a lot of electricity to run the SD card.
Current leakage test: apply 0.75 times 1mA reference voltage on both ends of lighting arrestor, current goes through lighting arrestor should not be higher than 50µA.
Alternatively, you can connect the external reference voltage to the AREF pin through a 5K resistor, allowing you to switch between external and internal reference voltages.
PMIC- Voltage Reference.
Family PMIC- Voltage Reference.
Voltage reference of module. Power supply 2.6V~ 5.5V DC.
DBV has a voltage reference of 0 dBV= 1 volt.
A voltage reference is included, or an external reference can be used.
This pin on the board provides the voltage reference with which the microcontroller operates.
Secretary at work is not always connected with the implementation of the voltage reference.