Examples of using Thread length in English and their translations into Greek
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Financial
-
Official/political
-
Computer
Thread length[367].
Inner Screw Thread Length.
Thread Length: 26.5mm.
With a male thread of M8*1,the thread length is 8mm.
Thread Length[mm] 11,7.
Availalbe size: M6-M48,and available with special thread length.
Min. Thread Length 75mm.
Availalbe size: M6-M48,and available with special thread length.
Thread length on bolts can vary.
Various head geometries or special thread lengths are available under this new standard.
Thread Length: The minimum thread length for standard lag screws shall be equal to½ the nominal screw plus.
Left and right of cardboard make a small hole and insert the thread length of about 50 cm.
(3) the fact thread length of screw that you use our thread rolling die to produce;
Regular oval eyebolts are supplies with a 4" or 6" thread length and one assembled square nut.
The various pdo thread lengths give the us a wide range of treatment options to lift and tighten skin anywhere.
Screws with a length longer than 6" have a minimum thread length of twice the diameter plus 1/2".
The minimum thread length is measured as twice the diameter plus 1/4" for screws 3/4" in diameter up to 6" long inclusive.
These bolts are intended for use in structural connections andit have shorter thread lengths than standard hex bolts.
For example, if processing 60mm thread length on 25mm diameter rebar, it will need 30-40 seconds.
JBG-40F adds screw pitch angle mechanism, it is eaiser to operate,save labor and the effective thread length maximum can be 200mm/300mm.
The threads have an accurate structure,so the thread length and straightness to allow them to easily engage threaded pipe.
The processing speed depends on many factors, such as the worker's proficiency, rebar grade,rebar diameter, thread pitch and thread length, etc.
When screw length is too short for the minimum thread length rule to apply, they shall be fully threaded.
The various PDO Thread lengths give the doctor a wide range of treatment options, that dissolve in a natural manner over a course of months, whilst synthesizing new collagen production in the treated area.
Added the opportunity to use the grades with different dimensions(such as modified head geometries or special thread lengths) by invoking Supplemental Requirement S2 and adding a“S” to the end of the grade(such as“A325S” or“A490S”).
When the thickness of the runner is used, the thread length l of the plug screw embedded in the bolt of the bolt is set to 1.5 times the diameter of the thread. .
Other length and thread can be produced.
Other length and thread can be produced as required.