Examples of using Microcontroller in English and their translations into Hindi
{-}
-
Colloquial
-
Ecclesiastic
-
Ecclesiastic
-
Computer
Microcontroller(MCU) Simulation.
It uses an NXP ARM Cortex M3 microcontroller and is quite powerful.
Microcontroller PLC techniques and 16 bit MCU, Visialbe adjustment screen.
In 1995, our business is focused on microcontroller wholesale and firmware design.
This pin on the board provides the voltage reference with which the microcontroller operates.
The use of microcontroller and dedicated software, intelligent control;
The signal is taken in by an Arduino microcontroller that I talk about later on.
The microcontroller does not require other hardware units as it is already enabled with it.
Creating a simple counter circuit using a PIC microcontroller with C language programming.
The 8-bit 8051 microcontroller was developed by Intel way back in 1980.
So for many makers it's an easy transition from an Arduino to an Atmel AVR microcontroller.
Inside an ISR of a microcontroller I am attempting to call a function as follows://adc.
None of these processors required, or supported,a Harvard bus across a single-board microcontroller.
Sine wave signalcan not be directly received by the microcontroller, the waveform must be transformed.
The microcontroller analyzes the initial signal with the final value and outputs the result to the user.
The pulsing brain of Alden'sroom is a bank of eight Arduino Mega microcontroller boards mounted on a plywood shelf.
The data flows out the microcontroller to each peripheral and back to the microcontroller.
From that, you can tell whether thealarm clock is going off or not and have your microcontroller and circuit do all sorts of cool things.
The microcontroller is the technology developed after the microprocessor and overcome the shortcomings of the microprocessor.
The vast majority of electronic products require a microcontroller or microprocessor to serve as the brains.
Lately, microcontroller development boards like the Arduino have been a popular choice because they have become very easy to work with.
CNC technology has evolved rapidly from the microcontroller technology of the'80s to PC-based controls in the late'90s.
For advanced products needing high-speed processing capabilities(i.e. a smartphone or tablet) then a microprocessor is necessary,otherwise a microcontroller is usually the best solution.
A simple AUV can be constructed from a microcontroller, PVC pressure housing, automatic door lock actuator, syringes, and a DPDT relay.
Much like the brain inside your own bone-plated noggin, your microcontroller needs protection from the outside world from time to time.
On the other hand, a microcontroller is a specialised microprocessor considered as“computer on a chip” as it integrates components like microprocessor, memory and parallel digital I/O.
For implementation be established composed of a microcontroller systems, a module Bluetooth, and laser transmitters and receivers.
Unlike microprocessor the microcontroller is not dependent on other hardware units, it contains all the essential block for the proper functioning.
In Circuit Programming(ISP): ISP allows you to program a microcontroller while it is installed in the application circuit, instead of having to remove it for programming.
CNLohr is serving this from a microcontroller attached to a circuit built on a microscope slide so he can blink an LED from within Minecraft.