Examples of using Cable cross-section in English and their translations into Hungarian
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Financial
-
Programming
-
Official/political
-
Computer
Choice of cable cross-sections.
There are special tables that present data to compare the amount of current,power consumption and cable cross-section.
Copper and aluminium cable cross-section calculation.
Calculation of the required cable cross-section.
How to calculate the cable cross-section, so that it does not overheat- Build Daily Toggle navigation.
The transfer rate on thebus is dependent on the cable length, the cable cross-section and the number of nodes.
How to calculate the cable cross-section, so that it does not overheat.
The greater the cable length, the lower the possible transmission rate will be and a larger cable cross-section must be selected.(see Figure 2).
The calculation of the cable cross-section of current, power, length.
Cable cross-section be not less than 16 mm², if product is designed for currents up to 150 A, 25 mm²- at 200 A and even 35 mm², if expected to work with the current 250 A above.
Calculation of the required cable cross-section- Build Daily.
If during operation of the finished wiring you add powerful consumers, and will operate the machine, can not simply be replaced by a more powerful machine,you must change both the cable cross-section, and the machine.
And this applies not only to cable cross-section, but also the structure of the line.
Note that to connect kitchen electricstove need to use copper 3-hzhilny cable cross-section of not less than 4 square millimeters.
Very often, tenants use the cable cross-sections less than needed(to save), which soon causes a short circuit.
Content 0.1 Table recruiting section of the wire depending on the power(W)1 How to make your own cable cross-section along the length of the calculation?
Connecting cable in accordance with VDE/KTW, cable cross-section and length per customer request Installation and operating instructions.
How to properly and accurately to make a cable cross-section calculationfor loss of voltage?
While, in some cases, much larger cable cross-sections have to compensate for the voltage drops that occur due to the longer cable lengths, Turck's excom I/O solution guarantees a stable power supply even with cable lengths of several hundred meters.
This separation is necessary for the optimum selection of the cable cross-section and the circuit breaker according to the expected loads.
Program to calculate the power cable cross-section for 3 Tips professionals Learn section of the cable for power and length of wires.
Enough to hold convector to each separate branch of a powerful electric cable cross-section of at least 2.5 square and protect her separate circuit breaker.
In accordance with Scheme calculate lengthdifferent cable cross-sections, the number of switches, sockets, the corresponding parameters machines(single-phase machines are activated for a short circuit and a significant overload and differential automatic trigger for a short circuit and stray currents).
To summarize the power to the heating tank is necessary tocarry out the electrical panel from the apartment separate cable cross-section of copper conductor of at least 2.5 mm, and the board is required to be equipped with protective devicesRCD.
Based on the results obtained, the cable cross-section is calculated, which should fully correspond to the design capacity.
Thanks to the flexible setting options, the final length,lay length, cable cross-section, outer diameter of the cable and open ends can all be varied.
In this case, it is necessary to begin to calculate the cable cross-section and in accordance with the calculated characteristics to choose the appropriate model.
In the automotive industry, for example,smaller and smaller cable cross-sections are required due to their lower weight and the smaller installation space required.
The cross-section of the cable.
