Examples of using Capacitive reactance in English and their translations into Indonesian
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Ecclesiastic
Xc= capacitive reactance in ohms.
As frequency increases capacitive reactance decreases.
XC= capacitive reactance, measured in ohms.
In F(Farad), and XC is the capacitive reactance in ohms.
XC- the capacitive reactance, which is measured in ohms.
How filter capacitors work is based on the principle of capacitive reactance.
XC is capacitive reactance.
XC= the capacitive reactance in ohms.
Resonance occurs when inductive reactance is equal to capacitive reactance i.e. XL= XC.
Where XC= capacitive reactance in ohms.
With capacitors, the smaller the capacitor, the larger the impedance(known as capacitive reactance).
Xc is the capacitive reactance.
A post orscrew that only partially penetrates into the waveguide acts as a shunt capacitive reactance.
You can see that the capacitive reactance decreases with frequency.
Depending on whether it is +90(lead) or -90(lag)it is called an inductive reactance or capacitive reactance.
Capacitive reactance is how the impedance(or resistance) of a capacitor changes in regard to the frequency of the signal passing through it.
Harmonic resonance occurs when the inductive reactance and the capacitive reactance of the power system become equal.
Resonance: Resonance in an electrical system occurs wheninductive reactance of the circuit becomes equal to capacitive reactance.
When there is inductive reactance or capacitive reactance also present in the circuit, Ohm's Law must be written to include the total impedance in the circuit.
Capacitive reactance X C{\displaystyle\scriptstyle{X_{C}}} is inversely proportional to the signal frequency f{\displaystyle\scriptstyle{f}}(or angular frequency ω) and the capacitance C{\displaystyle\scriptstyle{C.
So, we can summarize the behaviour of a capacitor in a variablefrequency circuit as being a sort of frequency controlled resistor that has a high capacitive reactance value(open circuit condition) at very low frequencies and low capacitive reactance value(short circuit condition) at very high frequencies as shown in the graph above.
Inductive reactance can only be canceled by capacitive reactance, so we have to add a capacitor in parallel to our example circuit as the additional load.
Above or below resonance, the iris acts as a capacitive or inductive reactance.
As frequency approaches infinity, the capacitive impedance(or reactance) approaches zero and the ESR becomes significant.
As frequency approaches infinity, the capacitive impedance(or reactance) approaches zero and the ESR becomes significant.
The Q factor of an inductor can be found through the following formula,where R is its internal electrical resistance and ω L{\displaystyle\omega{}L} is capacitive or inductive reactance at resonance.
The Q factor of an inductor can be found through the following formula,where R is its internal electrical resistance and is capacitive or inductive reactance at resonance.
Hence: if Xgt; 0{\displaystyle\scriptstyle Xgt;0}, the total reactance is said to be inductive; if X 0{\displaystyle\scriptstyle X=0}, then the impedance is purely resistive; if X< 0{\displaystyle\scriptstyle X<0},the total reactance is said to be capacitive.