Examples of using Change in capacitance in English and their translations into Indonesian
{-}
- 
                        Colloquial
                    
- 
                        Ecclesiastic
                    
- 
                        Computer
                    
- 
                        Ecclesiastic
                    
Change in capacitance shall not exceed 10% from the initial measurement.
The controller then detects the position of touch by measuring the change in capacitance at the four corners of the screen.
Capacitive devices use the change in capacitance between the sensing diaphragm and a fixed plate to measure pressure.
The computer orthe controller then detects the position of touch by measuring the change in capacitance at the four corners of the screen.
Gauges that rely on a change in capacitances are often referred to as Baratron gauges.
However, various factors can change  the structure of the capacitor, and the resulting change in capacitance can be used to sense those factors.
This represents the change in capacitance with temperature, expressed linearly as parts per million per degree centigrade(ppm/°C), or as a percent change  over a specified temperature range.
The sensors controller determines the position of the touch by from the change in capacitance measured from the four corners of the screen.
As the human body is also an electrical conductor, touching the surface of the screen results in  a distortion of the screen's electrostatic field,measurable as a change in capacitance.
For capacitors with voltage ratings of 15 VDC and below, change in capacitance shall not exceed+ 10%,- 25% from the initial measurement.
As the human body is also an electrical conductor, touching the surface of the screen results in  a distortion of the screen's electrostatic field,measurable as a change in capacitance.
The majority of mobile devices use capacitive touchscreen layers,which detect a change in capacitance when a finger or other conductive element touches the screen.
When a capacitive load(such as a human hand) is in  close proximity to the sense-pad,the sensor detects the change in capacitance and activates the switch.
Until here,we can get an interesting point of capacitive“touch” sensing that a measurable change in capacitance can be generated not only by contact between the finger and the sensor but also by proximity between the finger and the sensor.
Within the time-frame of the capacitance  change(as much as 50 ms at 20 Hz audio signal), the charge is practically constant andthe voltage across the capacitor changes  instantaneously to reflect the change in capacitance.
The capacitive shunt method, described in  an application note by Analog Devices(not to be confused with analog devices),senses the change in capacitance between a transmitter and receiver that are on opposite sides of the sensor.
Right: The new electrical approach: the relative change in capacitance C(T) caused by the measuring gas at a known temperature T, which is determined by means of a calibrated resistance thermometer R(T), can be directly linked to the gas pressure.
When a capacitive touchscreen is touched by human body(finger), an interruption is created in  thescreens electrostatic field(which is measurable as a change in capacitance) which is detected by phone's processor or chip and which in  turn instructs phone's operating system to trigger and event or action accordingly.
From these changes in capacitance, the acceleration can be determined.
Changes in capacitance at different scan rates result from that at low scan rates;
An algorithm converts these changes in capacitance into a location along the X and Y axes of the panel.
Parasitic capacitance in  high-performance integrated circuits can be measured in  femtofarads(1 fF 0.001 pF 10-15 F),while high-performance test equipment can detect changes in capacitance on the order of tens of attofarads 1 aF 10-18 F.
I assume that it would be possible to calibrate a capacitive sense system for rough distance measurements,but since capacitive sense circuitry is designed to detect changes in capacitance, it follows that this technology is particularly suitable for detecting changes in  distance, i.e., when a finger is moving closer to or farther from a sensor.
The membrane movement can be sensed using a strain gauge,piezoelectric, or changes in capacitance techniques(older techniques included magnetic and carbon pile devices).
To make it easier to detect the changes in capacitance, Bao stuck the PDMS capacitor onto an organic transistor, which can read out the differences as a change in  current.
We are looking only for changes in capacitance, and we can detect these changes  without knowing the nominal value of the PCB capacitor.
The process of adjusting them requires patience because the presence of your hand andthe tool will slightly change the capacitance of the circuit in the region of the trimmer!