Examples of using Error detection in English and their translations into Indonesian
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Ecclesiastic
The error detection capability.
Each is sent with a 4-bit CRC for error detection.
Error detection and correction is easy.
Logical link management: used for flow control and error detection.
Error detection is performed as follows.
People also translate
Logical Link Control- used for flow control and error detection and.
Error detection- Identifies fault conditions.
NetBEUI is also self-tuning and implements flow control and error detection.
SLIP lacks any error detection, whereas PPP implements it.
Diagnostic functions of a PLC controller allow for fast and easy error detection.
Error detection is much simpler than error correction.
IP makes no guarantees concerning reliability, flow control, error detection or error correction.
In that case, only error detection and canceling of erroneous packets are provided.
(Q) Which layer combines bits into bytes and bytes into frames, uses MAC addressing,and provide error detection?
SLIP does not provide error detection, being reliant on other high-layer protocols for this.
In MVC if you set MvcBuildViews to true then it compiles the markup code andyou get error detection, which is very useful.
Error detection: The operating system needs to be constantly aware of possible errors. .
If a scratch is deep orwide enough to affect laser focus, error detection and correction can usually recover the data.
Error Detection and Handling- The data link layer handleserror that occur at the lower levels of the network stack.
Controls how data is placed onto the media andis received from the media using techniques such as media access control and error detection.
The total overhead for the error detection and retransmission method is only 2001 bits per megabit of data, versus 10,000 bits for a Hamming code.
Controls how data is placed onto the media and is received from the media usingtechniques such as media access control and error detection.
Error detection is the detection of errors caused by noise or other impairments during transmission from the transmitter to the receiver.
The purpose of testing is verification, validation and error detection in order to find problems- and the purpose of finding those problems is to get them fixed.
The control information provides data the network needs to deliver the user data; for example:source and destination, error detection codes, and sequencing information.
A communications protocol is the set of standard rules for data representation, signaling,authentication and error detection required to send information over a communications channel.
The control information provides data the network needs to deliver the user data,for example source and destination addresses, error detection codes like checksums, and sequencing….
This required modems that could transmit data faster, leadingto the introduction of compression techniques to increase data rates and error detection and correction techniques to improve reliability.