Examples of using Four bits in English and their translations into Indonesian
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Ecclesiastic
Four bits is called a‘nibble'.
Half a byte(four bits) is called a nibble.
A nibble is just half of a byte, or four bits.
A group of four bits is called a'nibble'.
Each Hexadecimal digit is represented by four bits of binary digit.
The first four bits of a multicast IP address are 1110.
This was a specialintegrated circuit that was able to process four bits of data at a time.
Each group of four bits makes up a hexadecimal, or base 16.
Each decimal digit is stored in one byte, with the lower four bits encoding the digit in BCD form.
Very first four bits of the first octet in Class D IP addresses are set to 1110.
Because most people can only remember about three or four bits of information at once.
It takes four bits to represent a single BCD or hexadecimal digit.
A x2 link contains eightwires and transmits two bits atonce,a x4 link transmits four bits, and so on.
The next twenty four bits(the last three octets) is used to represent the host ID.
A x2 link contains eight wires and transmits two bits at once,a x4 link transmits four bits, and so on.
Each 74181 had a bus width of four bits, hence the popularity of bit-slice architecture.
When using hexadecimal encoding,each character in the final encryption key is four bits long when converted to binary.
The first four bits of the PCF8574's 7-bit address are 0100, and those for the PCF8574A are 0111.
In RAM, transistors make up the individual storage cells which can each"remember" an amount of knowledge, for example,one or four bits- as long as the PC is switched on.
In BCD, a numeral is usually represented by four bits which, in general, represent the decimal range 0 through 9.
The upper four bits, called the"zone" bits, are usually set to a fixed value so that the byte holds a character value corresponding to the digit.
Unpacked: Each number is encoded into one byte, with four bits representing the number and the remaining bits having no significance.
In byte-oriented systems(i.e. most modern computers), the term unpacked BCD usually implies a full byte for each digit(often including a sign), whereas packed BCD typically encodes two decimal digits within asingle byte by taking advantage of the fact that four bits are enough to represent the range 0 to 9.
When a CPU activates one of the leading four bits in a word IR010, relay contacts move and connect lines attached to it.
As most computers deal with data in 8-bit bytes, it is possible to use one of the following methods to encode a BCD number: Unpacked:Each number is encoded into one byte, with four bits representing the number and the remaining bits having no significance.
Since you now have four bits to make subnets with, you only have four bits left for host addresses.
Specify what logic states would have to be input at the PL, CE, and Clk terminals of each shift register, and at what times,to successfully load four bits of parallel data, shift them serially over the coaxial data cable, and then hold them at the outputs(Q) of the receiving shift register.
For example, I will use four bits, which means I have 16 possible values for the loudness, so the first four sections of the signal could be approximated by about 10, 12, 14, and 15.
And a four bit unsigned number can represent values from 0 to 15.
