Examples of using Half-duplex in English and their translations into Indonesian
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Ecclesiastic
Half-duplex and full-duplex mode;
The transmission mode is half-duplex.
Data Half-duplex transparent data transmission(OSD UART).
Support full-duplex flow control/ half-duplex back pressure mode.
As a part of a shared collision domain, hubs must use half-duplex.
Half-duplex stop-and-wait because IBM mainframes did not support full-duplex communication;
CSMA/CD is still supported for backwards compatibility and for half-duplex connections.
An example of a half-duplex device is a walkie-talkie two-way radio that has a"push-to-talk" button;
The radios all of us normally use, best CB radio or Walkie Talkie,operate in half-duplex mode.
A good analogy for a half-duplex system would be a one-lane road with traffic lights at each end.
Supports 802.3x flow control on full-duplex andBack-pressure flow control on half-duplex.
A good analogy for a half-duplex system would be a one-lane road with traffic lights at each end.
Support cut-through transmission and full-duplex flow control/ half-duplex back pressure mode.
Marine VHF mostly uses"half-duplex" transmission, where communication can only take place in one direction at a time.
All ports supportfull duplex 802.3x flow control and half-duplex back pressure Flow Control.
A half-duplex(HDX) system provides communication in both directions, but only one direction at a time(not simultaneously).
For computer to computer data exchange,this mode of transmission is more efficient than half-duplex transmission.
In half-duplex we have the ability to transfer as well as receive on one channel, although not at the same time.
Power priority mechanism, fast and forward, MAC automatic learning and aging IEEE802.3XFull-duplex and mode and backpressure for Half-duplex mode.
In a half-duplex system, there are still two clearly defined paths/channels, and each party can communicate with the other but not simultaneously;
Push-to-Talk(PTT), also known as Press-to-Transmit, is a method of conversing on half-duplex communication lines, including two-way radio, using a momentary button to switch from voice reception mode to transmit mode….
Half-duplex systems are usually used to conserve bandwidth, since only a single communication channel is needed, which is shared alternately between the two directions.
Summary Push-to-talk(PTT), also known as press-to-transmit,is a method of having conversations or talking on half-duplex communication lines, including two-way radio, using a momentary button to switch from voice reception mode to transmit mode.
A good analogy for a half-duplex system would be a one-lane road with traffic controllers at each end, such as a two-lane bridge under re-construction.
These ports detect the network speed and auto-negotiate between 10BASE-T and 100BASE-TX,as well as between full and half-duplex, to get you the maximum speed possible for each device connected to your network, for faster browsing, video streaming.
Many radio systems operate on a half-duplex method, which is why people signal when they are going“out,” alerting the other user to the fact that the frequency is open for transmission.
Half-duplex(stop and wait), full-duplex(sliding windows with selective retransmission), and continuous streaming transport can be used to adapt to any connection.
Technologies that employ half-duplex operation are capable of sending information in both directions between two nodes, but only one direction or the other can be utilized at a time.
The half-duplex mode is used in cases where there is no need for communication in both directions at the same time; the entire capacity of the channel can be utilized for each direction.