Examples of using Intermediate frequency in English and their translations into Indonesian
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Ecclesiastic
Intermediate Frequency Power.
The Intermediate Frequency(IF) Stage.
Those new signals are known as an intermediate frequency(IF).
The intermediate frequency(IF).
This lower frequency signal is referred to as the IF(intermediate frequency).
The intermediate frequency is 100 MHz.
The output of the mixer is a 10.7 MHz intermediate frequency(IF) signal.
There are three intermediate frequency electric furnaces in our foundry shop, with a capacity of 1-ton, 2-ton and 4-ton individually.
The general process of dust removal process for intermediate frequency furnace is as follows.
When the steel is tapping, the intermediate frequency furnace platform is turned out directly into the ladle on the flat car of the tapping track.
Carrier-to-noise ratio measured either at the Radio Frequency(RF) or Intermediate Frequency(IF).
Equipped with 1 tons, 2 tons,5 tons intermediate frequency furnace, we can manufacture 8-10 tons casting once time.
C/N- Carrier to Noise Ratio-is measured either at the Radio Frequency(RF) or Intermediate Frequency(IF).
(1) to the selected raw materials into the intermediate frequency electric furnace steel smelting, the molten steel temperature of 1600-1600℃;
A large number of flue gas will be produced during smelting,charging and tapping of intermediate frequency furnaces for smelting flue gas.
The basic direct output signal in an intermediate frequency based obtained directly from a television camera, satellite television receiver, or video tape recorder.
This is in contrast to the standard superheterodyne receiver where thisis accomplished only after an initial conversion to an intermediate frequency.
This is made practical by transferring the signal from the carrier onto an intermediate frequency in the radio by a process called heterodyning.
Our KGPS Series of Intermediate Frequency Power Supply fit for smelting, pipe hot expansion, quenching, drying, induction bending, etc, low loss of reactive power, high power aspect.
The high potential therapy device simulates and rebuilds the natural electric filed mainly through the high potential negative potential,anion, and intermediate frequency potential.
DIRECTV uses two 500 MHZ wide bands of spectrum as an intermediate frequency(IF) to transfer Ka band signals from the Dish/LNB's to their receivers.
Trimmers like trimmable inductors and trimmable capacitors are usually found in superhet radio andtelevision receivers, in the Intermediate frequency, oscillator and RF circuits.
The basic direct output signal, which is in an intermediate frequency base and is obtained directly from a television camera, satellite TV receiver, or video recorder.
These are typically surface acoustic wave(SAW) devices,and act as bandpass filters in both the radio frequency and intermediate frequency sections of the transceiver electronics.
Coating system uses 1-2 intermediate frequency magnetism to control the sputtering power source, has 1-2 pair of non- balanced magnetism to control the target, and has 6-40 arc sources.
(1) In the induction hardening of the gear, Miter Gearbox the intermediate frequency, especially the high frequency heating, tends to overheat at the sharp corners.
A large number of flue gas will be produced during smelting charging andtapping of intermediate frequency furnaces for smelting flue gas According to the operation technology of medium frequency furnace it is economical reasonable and feasible to….