Examples of using Modulus of elasticity in English and their translations into Indonesian
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Ecclesiastic
Low modulus of elasticity.
Hafnium has a low modulus of elasticity;
Modulus of Elasticity E.
The value of modulus of elasticity for.
Strength: strength should consider its grip andthe ability to resist splitting and modulus of elasticity.
Low modulus of elasticity.
The coefficient of the proportion is called the modulus of elasticity or Young's modulus. .
The modulus of elasticity of beryllium is approximately 1/3 greater than that of steel.
Due to the steel isotropic,quality of a material is uniform and modulus of elasticity, that make steel.
Static Modulus of Elasticity Concrete has no clear-cut modulus of elasticity.
As the result, compression strength, tensile strength, buckling strength and modulus of elasticity will be improved to some extent.
Where E= modulus of elasticity of the material, Imin= the minimal moment of inertia of the cross section, and L= actual length of the column between its two end supports.
As the result, compression strength, tensile strength, buckling strength and modulus of elasticity will be improved to some extent.
Dynamic Modulus of Elasticity The dynamic modulus of elasticity, which corresponds to very small instantaneous strains, is usually obtained by sonic tests.
Refractory metals have a high melting pointcoupledwith a low vapor pressure, high modulus of elasticity and high thermal stability.
If the fiber's modulus of elasticity is higher than the matrix(concrete or mortar binder), they help to carry the load by increasing the tensile strength of the material.
More attention and evaluation will be necessary if the job specification sets limits for other concrete properties such as creep,shrinkage, and modulus of elasticity.
Due to the steel isotropic,quality of a material is uniform and modulus of elasticity, that make steel bridge in the working condition and calculation compared with the assumption.
Smaller maximum size aggregate such as⅜ inch(9.5mm) can be used to produce very high compressive strength but required properties like creep, shrinkage,and modulus of elasticity may be sacrificed.
Its characteristics are small density, high specific strength, large modulus of elasticity, good shock absorption, high impact resistance, and better corrosion resistance.
In order to carry out this work and Henri Treca, the director of the Conservatoire des Arts et Metiers, conducted valuable research on the structural properties of cast iron,definitively establishing the modulus of elasticity applicable to compound castings.
From theoretical considerations, lower creep and shrinkage, and high modulus of elasticity can be achieved with higher aggregate and lower paste volumes in the concrete.
If the applied stress is sufficiently low(or the imposed strain is small enough), almost all solid materials behave in such a way that the strain is directly proportional to the stress;the coefficient of the proportion is called the modulus of elasticity.
Its characteristics are small density, high specific strength, large modulus of elasticity, good shock absorption, high impact resistance, and better corrosion resistance. After the….
The multiplicity of definitions, and corresponding multiplicity of hardness measuring instruments, together with the lack of a fundamental definition, indicates that hardness may not be a fundamental property of a material, but rather a composite one including yield strength, work hardening,true tensile strength, modulus of elasticity, and others.
The castings of hydraulic solenoid control valves' housing must have enough sufficient strength, toughness,molecular density, modulus of elasticity and other mechanical properties in order to withstand the high working pressure.
The fiberglass geogrid has a high tensile strength in the longitudinal andtransverse directions, low elongation, high modulus of elasticity, excellent high and low-temperature resistance, and excellent alkali resistance and aging resistance after surface coating treatment.
Subpart 2 of Part D has tables and charts providing physical properties,such as coefficient of thermal expansion, moduli of elasticity, and other technical data needed for design and construction of pressure-containing components and their supports made from ferrous and nonferrous materials.