Examples of using Total capacitance in English and their translations into Indonesian
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Ecclesiastic
When three capacitors are joined in series, the total capacitance is?
Therefore, the total capacitance of a 600 W motor should be at least 42 microfarads.
When capacitors are connected in series, the total capacitance is less than any.
Therefore, the total capacitance of a 600 W motor should be at least 42 microfarads.
There are two storageprinciples in the electric double-layer of the electrodes that contribute to the total capacitance of an electrochemical capacitor:[21].
The total capacitance calculation for series and parallel circuits are similar to that of resistors.
When capacitors are connected in parallel the total capacitance is equal to the sum of the single capacitances. .
The total capacitance of the electrodes was 1nF when measured in air which indicates a large close surface area for gas production.
When capacitors are connected in series, the total capacitance is less than any capacitance of the series capacitor.
The capacitance value of an electrochemical capacitor is determined by two storage principles,both of which contribute to the total capacitance of the capacitor.
When the capacitors are connected serially then the total capacitance that is Ctotal is less any one of the capacitor's capacitance. .
This occurs because the addition of inductance in parallel lowers the total inductance,but the addition of capacitance in parallel increases the total capacitance by the same proportion.
For asymmetric capacitors, the total capacitance can be taken as that of the electrode with the smaller capacitance if C1>> C2, then Ctotal≈ C2.
Bristol University isworking on a complex series-parallel cell structure in which total capacitance and operating voltage can be controlled separately.
Additionally, depending on electrode material and surface shape, some ions may permeate the double layer becoming specifically adsorbed ions andcontribute with pseudocapacitance to the total capacitance of the supercapacitor.
Symmetry implies that both electrodes have the same capacitance value,yielding a total capacitance of half the value of each single electrode if C1 C2, then Ctotal½ C1.
Unlike ordinary capacitors, supercapacitors do not use the conventional solid dielectric, but rather, they use electrostatic double-layer capacitance and electrochemical pseudocapacitance,both of which contribute to the total capacitance of the capacitor, with a few differences.
There are two storageprinciples in the electric double-layer of the electrodes that contribute to the total capacitance of an electrochemical capacitor: Double-layer capacitance, electrostatic storage of the electrical energy achieved by separation of charge in a Helmholtz double layer.
The University of Bristol is going much further byproducing a complex series-parallel cell structure in which both the total capacitance and operating voltage can be separately controlled.
Unlike ordinary capacitors, supercapacitors do not use the conventional solid dielectric, but rather, they use electrostatic double-layer capacitance and electrochemical pseudocapacitance,both of which contribute to the total capacitance of the capacitor, with a few differences: Electrostatic double-layer capacitors(EDLCs) use carbon electrodes or derivatives with much higher electrostatic double-layer capacitance than electrochemical pseudocapacitance, achieving separation of charge in a Helmholtz double layer at the interface between the surface of a conductive electrode and an electrolyte.
Its frequency of oscillation is determined by the value of the inductance and the total parallel capacitance.
Toward the end of the drop life,there is little change in the surface area which diminishes the contribution of capacitance changes to the total current.
This formula shows that the total charge on a capacitor is equal to the capacitance multiplied by the voltage across the capacitor.
The currents through the inductance and capacitance can be much higher then the current of the total circuit.
In such cases,the entire body is treated as lumped capacitance heat reservoir, with total heat content which is proportional to simple total heat capacity, and the temperature of the body.
The total voltage difference from end to end is apportioned to each capacitor according to the inverse of its capacitance.
The capacitor's value(its'capacitance') is largely determined by the total surface area of the plates and the distance between the plates(determined by the insulator's thickness).
The ground capacitance of single branch≤8uF, the ground capacitance of total system≤100uF.