Examples of using Command mode in English and their translations into Japanese
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Programming
I often use command mode.
Vi enter command mode(use alternative key bindings).
This is also known as command mode.
You will be in command mode when you first start editing a file.
When first invoked, ed is in command mode.
You can jump line in command mode to use by pressing Esc key.
See below. This is also known as command mode.
Editor vi is in command mode after start.
This is the key map used in vimode command mode.
Command Mode: The action when it is selected the command. .
Set display/ non-display of line number in vim command mode.
When in command mode, the normal terminal editing conventions are available.
Instead of, you can search tabs in the command mode, and select it.
O In command mode there is no support for entering numbers from left.
Faq-16.1 How do I use the name of the current file in the command mode or.
In command mode, it turns out the Autodoc has an option called Stabilize and Suspend.
Working mode: active mode, command mode, trigger mode. .
In Command mode, it turns out the autodoc has a option called"Stabilize and Suspend.
Ignoreeof also applies to mail command mode. Default is noignoreeof.
The command mode is independently selected for each axis and any combination is possible.
Here's how the terminal session will look,starting with the“+++” to enter command mode.
SPI also supports command mode, for the highest detailed diagnostic information.
List or change key bindings in the vi(1)mode alternate(command mode) key map.
Fix watchdog_setup command mode option to work correctly.(Takuma Hoshiai).
Designate the I/O15 pin as Low andthe EN pin as High to use the modeul in AT command mode.
Step 3: You will get into the Command mode and you will have to select on Common, normally option 6.
When a remote PPP peer is detected,ppp automatically enables Packet Mode and goes back into command mode.
Use an accelerator key when you want to enter a command mode but do not want any immediate action.
In the command mode, you can select next candidate by executing this command if search results have one more candidate.
Provides an interactive user interface. Using its command mode, the user can easily enter commands to establish the connection with the remote end, check the status of connection and close the connection.