Examples of using Microcontroller's in English and their translations into Japanese
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Programming
Data and Clock are read on the microcontroller's pins A and B, respectively.
Four of the microcontroller's six GPIOs are used to control output signals on SDA, SCL, and a single LED, and to accept one analog input.
The Arduino board exposes most of the microcontroller's I/O pins for use by other circuits.
This application notedescribes a software I2C driver for the MAXQ2000 microcontroller that permits I2C communication at 100kHz or 400kHz using any of the microcontroller's GPIO pins.
The MAXQ2000 microcontroller's WDT serves as an example of an internal watchdog.
Using a ferrite bead such as theTDK MMZ1608B601C to connect both grounds prevents the microcontroller's system clock and its harmonics from feeding into the analog ground.
This prevents the microcontroller's system clock and its harmonics from feeding into the analog ground.
Using a ferrite bead such as theTDK MMZ1608B601C to connect both grounds prevents the microcontroller's system clock and its harmonics from feeding into the analog ground.
For example, if an attacker can access the microcontroller's address and data buses, he or she could insert instructions to dump the key data to an external I/O port.
Thus when the analog output voltage is used tomeasure a certain current through the sense resistor, the microcontroller's ADC gives a current value between IEVALUATED(MIN) and IEVALUATEDMAX.
The MINIQUSB+ firmware in the MAXQ2000 microcontroller's nonvolatile flash memory only needs to be updated once.
MAX-IDE provides a standard include file for each MAXQ microcontroller which defines that microcontroller's peripheral register set as well as addresses for functions provided by the utility ROM.
If the diagnostic vectorlocation points to an encrypted memory region, the microcontroller's ROM will simply halt the processor after reset, which is the default action when DIAE=0 diagnostic routine not enabled.
The Arduino board exposes most of the microcontroller's I/O pins for use by other circuits.
This hardware stack is used to save and restore the microcontroller's operating state across subroutine calls and interrupt operations.
Secure embedded system using the DS5250. The general-purpose microcontroller's primary function is to execute a high-level operating system.
The latter mod is feasible because sinceAtmel haven't offered any new main microcontroller's firmware after Year 2009 until now sub's only role of updating main's firmware is considered to be dead.
No resources required from the application's microcontroller.
Today's microcontroller board market began with development boards.
Infineon's microcontroller family AURIX™, for example, currently has up to five cores.
Now the FPGA's microcontroller function comes alive and performs the challenge-and-response authentication, also known as identification friend or foe IFF.
A StANLE spacecraft's microcontroller would need to control read/write to the memory, regulate power, and poll sensors for data.
When the supply voltage falls below the voltage detector's threshold,its output asserts to notify the system's microcontroller of an impending power failure.
The main goal is to realize highly efficientpower control solutions built on Toshiba's microcontrollers and wireless communication ICs, plus ABLIC's power control ICs.