Examples of using Reactance in English and their translations into Japanese
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Programming
Psychological reactance theory.
Reactance calculation value of coil[Ω].
Addition of capacitors to an inductive circuit to offset reactance.
The reactance of this capacitor C When you calculate Z.
The value that corresponds to this resistance is called reactance(The unit is Ω) in the exchange.
The reactance of the coil corresponds to vector AB in blue+ jωL.
Referring to the graph on the right side, there is a point at which the reactance declines and crosses the resistance component.
LC reactance(calculation of LC reactance by each frequency).
Some of the larger OTS antennas mayhave impedances that are close to 50Ω with no reactance capacitance or inductance.
The reactance of coil L(impedance) in each frequency ZL is calculated by the following expression.
For a crystal-oscillator designer, the key parameters are those of the resonator itself:resonant frequency, reactance, and Q-factor.
The reactance of capacitor C(impedance) in each frequency Zc is calculated by the following expression.
Equipped suitable reactor like dry series iron core orair core in suitable reactance rate to suppress high times harmonic or closing inrush current.
The reactance components are dominant in the low frequency range and function as inductors that reflect noise.
Because of this, a part of the magnetic flux that should pass through the main circuit magnetically couples with the surrounding parts such as the case,causing leakage reactance and stray loss.
It is troublesome to calculate the reactance( impedance) separately by each frequency when the capacitor and the coil are used.
Also, as with resistor dividers, the divider ratio of a capacitive voltage divider is not affected by changes in the signal frequency even thoughthe capacitor reactance is frequency dependent.
Since the inductive reactance and capacitive reactance are different depending on the frequency, the current value also varies with the frequency.
I think that the value of the capacitor canoften select this cutoff frequency to the standard, and the reactance table of the following capacitor becomes reference very much when the circuit is designed.
Psychological reactance theory says that when we're exposed to opposition to our beliefs, our self-preservation instincts kick in to make us stick to them.
Thus, it is worthwhile to measure the driver's output impedance with a network analyzer andthen try to minimize the output reactance by adding a shunt capacitor or inductor.
(d) The antenna element 607 is connected with a reactance element 610 or 611 through a connection point 609 of the radio communication circuit 110.
According to psychological reactance theory, we respond to the loss of freedoms by wanting to have them(along with the goods and services connected to them) more than before.
Although the simplest solution- the line-side connection of an ohmic resistor- is inexpensive, it does generate high losses and thus opposes the high efficiency rates required.Exploiting the reactance of capacitors to practical effectOne possibility for supplying small loads from the AC power supply that is not only elegant, but also simple and cost-effective, is to connect the capacitor and load in series.
Magnetic coupling with the surrounding parts: Leakage reactance, stray loss Control waveform harmonies: Harmony iron loss, magnet eddy current loss Electromagnetic excitation force and machine resonance: Vibration, noise The number of cases in which, due to miniaturization and density growth, motors have to be restricted to a limited space has started to increase.
When the oscillation mode is in a steady state, the relations among the reactance of crystal unit Xe, circuit reactance-X, impedance of crystal Re and circuit impedance-R are as follows:.
In this mode, the crystal's total reactance is slightly inductive and is in parallel with the oscillator's load capacitance, forming an LC tank circuit which determines the oscillator frequency.
At the resonant-matching network frequency of 315MHz,the tiny loop resistance is transformed by the series reactance of the loop and C1 to an equivalent parallel circuit with the optimum load resistance of 125Ω best load impedance for maximum MAX7044 efficiency.
Good grounding in this application means minimizing inductive reactance between the top component layer and the ground plane, forcing two different ground points to have a potential difference of 0V and preventing stray signals from coupling from one stage to the next.
The Q factor of an inductor can be found through the following formula, where R is its internal electrical resistance and ωL is capacitive orinductive reactance at resonance: By using a ferromagnetic core, the inductance is greatly increased for the same amount of copper, multiplying up the Q. Cores however also introduce losses that increase with frequency.