Examples of using Switch-mode in English and their translations into Japanese
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Programming
Switch-mode BEC, brushless ESC(installed).
The second set of noise sources(67kgt; 200 MHz)is caused by Switch-Mode Power Supplies(SMPS).
Better efficiency can be obtained using a switch-mode power supply for the fan, but this increases cost and component count.
As a result, RS now offers a selection of more than 1000 TDK-Lambda units direct from stock,including highly popular embedded switch-mode power supplies(SMPS) and isolated DC-DC converters.
Its low impedance power path optimizes switch-mode operation efficiency, reduces battery charging time and extends battery life during discharging phase.
The MAX16127 provides limiter-mode fault management for overvoltage and thermal shutdown conditions;whereas the MAX16126 provides switch-mode fault management for overvoltage and thermal shutdown conditions.
Figure 2. Using a switch-mode step-down converter driver minimizes the power dissipation and maximizes the driver efficiency in a light fixture.
Controlled by the temperature monitors IC1 and IC2, this switch-mode DC-DC controller(IC3) applies either 0V, 8V, or 12V to the fan.
For the switch-mode case, it may be necessary to retune the bootstrap circuit that helps to turn off Q1 depending on the extra load current and its affect on switching performance.
Refer to the MAX761 data sheet for a 150mA, PFM switch-mode DC-DC converter that operates from inputs as low as 2V.
Switch-mode power converters(e.g. switch-mode regulators, switch-mode amplifiers, DC/DC converters or DC/AC inverters) can have a negative dynamic input resistance at their power input terminals.
This application note presents an analysis of the DS2715 switch-mode circuit, along with an easy-to-use spreadsheet for estimating the switching frequency at various operating points.
For higher-current flash memory programming solutions, refer to the data sheets for the MAX734(120mA output current, guaranteed) and MAX732(200mA output current, guaranteed)PWM, switch-mode DC-DC converters.
Its low impedance power path optimizes switch-mode operation efficiency, reduces battery charging time and extends battery life during discharging phase.
This can interact with the impedance of an input filter,resulting in instability and even oscillation that can destroy the switch-mode converter and/or other equipment connected to the same power source.
The BQ25619/618 is a highly integrated 1.5-A switch-mode battery charge management and system Power Path management device for Li-Ion and Li-polymer battery.
Trend Enabling New Conveniences With switchable socket adaptors controlled by a mobile device, homeowners gain convenience in operatinglights with the bonus of saving money by isolating switch-mode power supplies from the mains.
The synchronous rectifier in a switch-mode power supply consists of a low-resistance conduction path across the Schottky diode, for the purpose of improving power-conversion efficiency.
Dr. Glaser worked at General Electric GlobalResearch where his included high performance switch-mode power converters, VHF amplifiers, induction heating, electronic ballasts, and magnetics, for applications ranging from lamp drivers to MRI.
Switch-mode power supplies(SMPSs) are frequently used to provide the various levels of DC output power needed for modern applications, and are indispensable in achieving highly efficient, reliable DC-DC power-conversion systems.
Introduction Conversion efficiency is a prime consideration for all switch-mode power supplies(SMPSs), but is even more critical for those found in portable devices, where prolonging battery life is a key goal.
Switch-mode and linear regulators distribute power cleanly and efficiently. Modern hand-held cellular-radio transceivers have the almost impossible task of selecting and demodulating a desired signal in the midst of many unwanted signals.
The bq24190, bq24192, and bq24192I are highly-integrated switch-mode battery charge management and system power path management devices for single cell Li-Ion and Li-polymer battery in a wide range of tablet and other portable devices.
Improved Efficiency Switch-mode power supplies have a place in modern cellular phones, and the latest SMPS ICs offer small size, high efficiency, low dropout voltage, small external components, and noise-control features.
This application note describes how a switch-mode power-supply controller such as the MAX774 and a diode-capacitor network can generate modest negative supply currents without the use of inductors.
Figure 1 Inrush current limiting in a switch-mode power supply Application: Inrush current limiting for industrial inverters Induction motors are often used for fans, pumps, air conditioners and other equipment in factories.
The bq24196 is highly-integrated switch-mode battery charge management and system power path management devices for single cell Li-Ion and Li-polymer battery in a wide range of tablet and other portable devices.
The bq24195L, bq24195 are highly-integrated switch-mode battery charge management and system power path management devices for single cell Li-Ion and Li-polymer battery in a wide range of power bank, tablet and other portable devices.