Examples of using The heat source in English and their translations into Polish
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Ecclesiastic
-
Financial
-
Official/political
-
Programming
-
Computer
The heat source is radioactive decay.
When it is difficult to detect the heat source.
From the heat source can be as low as 28°C.
When it is difficult to detect the heat source.
The heat source can act as air, earth, Water- the"classic" elements of nature.
People also translate
Avoid direct heating of piping by the heat source.
The heat source in the detection range is hardly actuated or moves at a high speed.
Leave on for 5 to 10 minutes, or5 minutes under the heat source.
After five seconds in standby, if the heat source isn't gone, we have an alarm.
But wooden crafts desirable very well insulated from the heat source.
Instead of a traditional sauna heater, the heat source in a steam room is a steam generator.
Usually, the farther away from the heat source, for example candle flame or stove, the cooler it gets.
Hello Family guesthouse andwinery Egerszalok leading to the heat source Ady Endre street.
Steam as the heat source realizes lower costs and easier maintenance of automatic cashew kernel dryer.
A protective layer should be placed between the dog's skin and the heat source to avoid burns.
One will be holding the limb over the heat source, and the other will be peeling the epidermis away.
For very damaged hair, cover your hair with a cap andleave on for 5 to 10 minutes under the heat source.
Steam as the heat source realizes lower costs and easier maintenance of automatic cashew kernel dryer.
Will provide ice(chilled) water, heating andhot water using a gas or oil burner as the heat source.
The heat source in the room can be a fireplace, which is better positioned by the foot of the bed.
It is important to ensure that the heat source to maintain to achieve a comfortable temperature on the balcony.
The heat source is either bleed-off vapour from the first evaporator effect or low pressure steam at 120°C.
Supply pipe which is connected to the hot water from the heat source and return pipe, which drains chilled water to the system.
Between the heat source and plastic installation put in metal pipe segment: 1,5 m length for calculation temperature 95ºC.
Research status of titanium alloy 3D printingThe SLM technology that uses laser as the heat source superimposes the metal powder layer by layer according to the set path.
Between the heat source and plastic installation put in metal pipe segment: 0,6 m length for calculation temperature below 60ºC.
If chunks of old grease fall through the grate and land on the heat source, the grease will vaporize and adhere to your protein, further destroying your attempt at making tasty food.