Examples of using The microcontroller in English and their translations into Polish
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Ecclesiastic
-
Financial
-
Official/political
-
Programming
-
Computer
Hover the mouse over the microcontroller component.
From the microcontroller side we use a control pin(X1) and GND.
It contains everything needed to support the microcontroller;
Thanks to the microcontroller control its own production is greatly simplified.
It seems however easier to wake up the Microcontroller from"idle mode.
The microcontroller monitors the DATA
Can be directly connected to the microcontroller.
Blank check- verifying for the microcontroller flash memory is blank.
Yellow: connected microcontroller output TTL level to the microcontroller.
One power supply for the microcontroller unit and a further one for the GPS antenna.
If this test works then you can be sure that the Microcontroller will work.
Directly connected to the microcontroller serial port, not through the MAX232 chip!
If this test works then you can be sure that the Microcontroller will work.
Solution: Check that the microcontroller unit and the GPS antenna unit are both powered on.
Solder the components together starting from the microcontroller and the EEPROM.
The microcontroller is pre-programmed with a bootloader So what a dedicated programmer is not necessary.
So I plugged in and I used the microcontroller to control the blinking.
On board, digital output interface can be directly connected with the microcontroller IO.
Allowing the player to play to get the microcontroller system development capabilities.
to provide the clock signal for the microcontroller.
Low-level signal when the output light can be directly connected to the microcontroller.
DS1302 between the microcontroller can simply adopt the way synchronous serial communication port only used three lines.
This pin on the board provides the voltage reference with which the microcontroller operates.
connected directly to the microcontroller.
Module DO output of the microcontroller the I/ O ports directly connected to the reed switch triggering state can be detected through the microcontroller;
Through the development kits, the user can easily gain access to all I/O lines of the microcontroller.
Small plates digital outputs D0 can be directly connected with the microcontroller, microcontroller to detect high