Examples of using Dimms in English and their translations into Russian
{-}
-
Official
-
Colloquial
Why would I use Registered DIMMs?
Support for up to 8 DIMMS of DDR3-1866 memory.
Why would I use Unbuffered ECC DIMMs?
Support for up to 8 DIMMS of DDR3-1600 memory.
Architecture 533 or 667 MHz(when available) Fully Buffered DIMMs FBD.
Install identical DIMMs in all four sockets OR.
For All Printers- no special printers orhardware extensions(like barcode DIMMs or SIMMs) required.
Unbuffered and registered DIMMs cannot be mixed in the same system.
To benefit from low-power DDR3L, all populated DIMMs must be 1.35V.
Maximum RAM 64 GB(8 GB dual-rank DIMMs) 128 GB(16 GB quad-rank DIMMs) when available.
LRDIMMs, or Load Reduced DIMMs, are a new type of industry standard memory module for servers.
The company also launched Fully Buffered Dimms(FBDIMMs), which broke the 16GB barrier.
Quad-rank DIMMs have a lower power usage per Gigabyte(GB) than any other DIMM type.
A single platform must use either all Registered DIMMs or all Unbuffered ECC DIMMs.
LRDIMMs are similar to Registered DIMMs that are used in the vast majority of servers today.
Please make sure to disconnect power supply before adding or removing DIMMs or the system components.
In two DIMMs per channel, or 2DPC(eight modules per processor in quad-channel configuration), DDR4-2133 RDIMMs will operate at 1866MT/s.
For use in computers, DDR2 SDRAM is supplied in DIMMs with 240 pins and a single locating notch.
Feel confident in the strength of your motherboard slots when using heavy graphics cards or memory DIMMs.
For 4- and 8-socket low-cost platforms,Kingston offers single DIMMs to install with the K3 kits, or K4 kits of 4.
You will get full bar code functionality without requirement for special printers orspecial hardware DIMMs or SIMMs.
In three DIMMs per channel, or 3DPC(twelve modules per processor in quad-channel configuration), DDR4-2133 RDIMMs will operate at 1600MT/s.
Higher model numbers support 1600MT/s, butmay be limited by the number of DIMMs per Channel that are installed.
The new platforms use DDR3Registered ECC DIMMs or DDR3 Unbuffered ECC DIMMs up to 1333MHz and feature Triple Channel architecture for enhanced performance.
The i-Series has four DIMM slots on its main logic board and supports standard unbuffered orregistered 100 MHz ECC SDRAM DIMMs.
Memory The mainboard provides two 240-pin unbuffered DDRII 400/ 533/ 667/ 800 SDRAM DIMMs, and supports the memory size up to 2GB.
Fewer DIMMs(Dual Inline Memory Modules) use less power- when possible, install the least amount of DIMMs to reach your application memory capacity needs.
Today, Dual Rank modules are available in 16GB capacities, but32GB RDIMMs are Quad Rank, which are limited to 2 DIMMs per Channel at much slower speeds.
Although the user guide for a computer system may state that the system requires PC100 168-pin synchronous DIMMs, it may not include other system-specific constraints.
This means that, on Intel E5 processor-based platforms,32GB LRDIMMs can be used in all the available memory sockets whereas 32GB Quad Rank RDIMMs are limited to a maximum 2 DIMMs per Channel(2DPC) configurations as illustrated in the table below.
