Examples of using Uart in English and their translations into Russian
{-}
-
Official
-
Colloquial
Two UART with data rates up to 3.6 Mbit/s.
Windows 98… XP software- USB drivers for uart.
Port UART running at 9600 with options 8E1.
Additional Interfaces: HDLC/SDLC, PCMCIA,SPI, UART.
Output format: UART signal 9600 bps baud rate.
Computer or terminal with a serial port 16650 UART recommended.
ML-12012. UART Other System SGC Module, UART Output.
Serial connector One 6-pin UART mini-DIN connector.
Micro UART cable(with 530K resistor) for Samsung C3303K- 1 pc.
Each port can work in UART, Wiegand, or clock/data modes.
All these operations are performed very fast via microusb uart cable.
Ser- controls the serial port UART, Wiegand, clock/data modes.
The UART interface can be programmed with the following options.
Digital interface- RS-485 or UART(RX, TX-3.3V), selected by the customer.
After Software request disconnect USB cable andconnect Samsung Micro UART cable.
To perform"Reset FRP UART(UFS chips)" operation, do the following steps.
The receiver communicates with consumer equipment through the UART using the NMEA protocol.
Survey on UART port, transmission control port is not used(it is for RS-485);
Windows Embedded Compact(formerly Windows CE) supports UART, USB, SDIO, and BCSP connections.
Figure 6: Block diagram UARTx Fig. 6 is a block diagram of serial UART interface controller.
It supports some Bluetooth protocols and layers,such as the H4 and BCSP UART layers.
V-MC800 module offers full range of interfaces:USB, UART, GPIO, I2C, Analog voice, PCM voice, SDIO and SPI.
The UART port is separately configurable and can be run as an asynchronous link from 1200 baud to 4M baud.
Expansion header- 40-pin Raspberry Pi compatible header with USB, UART, I2C, ADC, PWM, JTAG, I2S, and GPIOs.
Serial ports(2661 UART), one Centronics printer port(discrete TTL chips), light pen port.
Expansion header- 40-pin Raspberry Pi compatible header with USB, UART, I2C, ADC, PWM, JTAG, I2S, and GPIOs.
UART controller automatically generates a parity check bit during transmission and gen- erates parity check when receiving data.
An RS232 Tibbit placed into the same socket will require a UART to be enabled and mapped to this Tibbit's interface lines.
An upgraded version of the ALDL protocol appears which communicates at 8192 bit/s with half-duplex UART signaling.
The UART(Universal Asynchronous Receiver Transmitter) port is modeled after the industry standard 16550 UART devices.