Examples of using Resistivity in English and their translations into Serbian
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Latin
-
Cyrillic
What is the resistivity of air?
Resistivity depends on temperature.
As we know,no wires really have no resistivity.
Electrical resistivity- 6 times higher;
It is characterized by its high chemical and physical resistivity.
ΡT= resistivity at a temperature T.
Another factor that affects the resistivity is the temperature.
I believe that journalists here must possess a kind of resistivity.
To do this,we need to know the resistivity of the conductor material.
The inverse, or reciprocal, of thermal conductivity is thermal resistivity.
Thermal resistivity(1/ κ) characterizes a material's ability to oppose the flow of heat.
In addition, they exhibit high coercivity,high resistivity, and low density.
If required, the resistivity of the coating material is calculated from either of these measurements.
These materials combine a high magnetic permeability with a high material resistivity.
High purity 99.99% with high transmittance,low impurity contents and resistivity, Indium oxide is raw materal of the most widely used for indium tin oxides.
These materials combine high magnetic permeability with high bulk electrical resistivity.
The resistivity of the long silver nanowire films is several orders of magnitude lower than silver nanoparticles and only 10 times greater than pure silver,” Stewart said.
A journalist has to be aware of that andhas to have higher resistivity than the other people.
The corresponding resistivity of the graphene sheet would be 10- 6 Ω•cm, less than the resistivity of silver,the lowest resistivity substance known at room temperature.
Smart ROP series produce high quality pure water with superior resistivity and low TOC(<30ppb).
Since the dielectric constant,dielectric loss tangent value, and volume resistivity are high, the corona resistance is not very good, and it is generally suitable for medium or low voltage and low frequency insulation materials.
The method is applicable to products having a conductivityless than 5 µS/cm, corresponding to a resistivity greater than 200 kΩ⋅cm.
It is known that the theoretical maximum electrical resistivity for water is approximately 18.2 MΩ·cm(182 kΩ·m) at 25 °C. This figure agrees well with what is typically seen on reverse osmosis, ultra-filtered and deionized ultra-pure water systems used, for instance, in semiconductor manufacturing plants.
Thermal resistance(R) measures an object's resistance to heat flow, andis determined by both its thermal resistivity and its geometry.
The antistatic aluminum-plastic panel is coated with an anti-static coating to form an aluminum-plastic panel,and the surface resistivity is below 109 Ω, which is smaller than the surface resistivity of the ordinary aluminum-plastic panel so that static electricity is not easily generated, and dust in the air is not easily attached to the surface.
The chemical specification for electrolytic grade copper is ASTM B 115-00(a standard that specifies the purity andmaximum electrical resistivity of the product).
The qualifier"in a given state" is usually interpreted as meaning"at a constant temperature," since the resistivity of materials is usually temperature dependent.
The thermal resistance of an object is a ratio of the difference in temperature to the power dissipated, andcan be expressed as a function of the object's geometry and thermal resistivity.
After substitution of R from the above equation into the equation preceding it, the continuum form of Ohm's law for a uniform field(and uniform current density) oriented along the length of the conductor reduces to the more familiar form: V= I R.{\displaystyle{ V}={ I}{ R}.\} A perfect crystal lattice, with low enough thermal motion and no deviations from periodic structure,would have no resistivity, but a real metal has crystallographic defects, impurities, multiple isotopes, and thermal motion of the atoms.
Determination of energy gap a via optical method b thermical method 2. Determination of concentration, mobility andtype of majority carriers through measuring Hall constant and specific electrical resistivity of semiconductor.