Examples of using Maximum current in English and their translations into Slovak
{-}
-
Colloquial
-
Official
-
Medicine
-
Financial
-
Ecclesiastic
-
Official/political
-
Computer
-
Programming
Maximum Current rating 16A.
Efficiency at maximum current(I2).
Maximum current from an output+U(electronic fuse).
Efficiency at maximum current(I2).
The maximum current that we are able to download is significantly reduced.
Set the test voltage, maximum current, time and start.
The maximum current is 160 A, and the electrodes are supplied with a diameter of 1.6 cm and 2 cm.
Constant voltage output and the maximum current of 5A/ch.
Assume the maximum current of 16A. Multiply by 1.25, we obtain 20A.
There channels for RGB output, each allows a maximum current of 4A.
To apply the maximum current, the background noise must remain unchanged.
There channels for RGB output, each allows a maximum current of 4A.
It is the maximum current that can offer any motherboard PCI-E slot.
The value of the resistor is set so thatyou do not exceed the maximum current on the pin.
Peak current: The maximum current that a power supply can provide for brief periods.
If the power supply operates on continuous basis,the output current cannot exceed 80% of the maximum current(ca. 1 A).
It is limited by the maximum current capability of the power supply and controlled by internal protection circuits.
The six outlets are split into three isolated sections,offering 9V and 12V of power with a maximum current of 200mA for each section.
In this case, the maximum current will reach 125-130 A, therefore it is advisable to use a transformer device T3.
This kind of complex is able to supply for a shortterm higher current also than is maximum current of the stabilized power supply.
For home use, you can opt for models that have a maximum current of 160 A, but only with the condition that the grid will produce a voltage of 210 V.
The T-Rex Fuel Tank Junior provides you with five fully isolated 9V DC outputs,ideal for pedals with a maximum current draw of 120mA.
The base potentiostat/galvanostathas a compliance voltage of 20 V and a maximum current of 400 mA, which can be expanded to 10 A with the BOOSTER10A option.
If the power supply is intended for continuous operation(24h),the rated current should not exceed 80% maximum current.
For instance, you can increase the maximum current, enable low-current measurements, implement a true analog sweep for cyclic voltammetry, and much more.
Transformer action limits the induced voltage in the loop,and the weak coupling limits the maximum current that will flow, even if the loop resistance is very low.
Therefore, to find the maximum current a trace can safely carry, we must find a way to estimate the heat rise associated with the applied current. .
Class 2 Circuits” are energy-limited circuits with a maximum voltage of 30V AC or42V DC, a maximum current of 5A and a maximum power rating of 100 VA.
For instance, you can add modules to enable Electrochemical Impedance Spectroscopy(EIS),to increase the maximum current, or to increase the sampling rate, and many more.
Short circuits between the power-supply output andground can create currents within the system that are limited only by the maximum current capability and internal impedance of the power supply.