Examples of using AUTO button in English and their translations into Spanish
{-}
-
Colloquial
-
Official
Press the AUTO button on the remote.
The AirMonitor can be switched on with the AUTO button see fig. 3E.
The AUTO button light is displayed on the LCD.
To switch off, press the button again, or press the AUTO button.
Press AUTO button if you want to return to auto mode.
The word“AUTO” will appear andthe LED light above the AUTO button will illuminate.
Press the AUTO button for automatic control of the blower speed.
To use the autotune function through the front panel controls,press the AUTO button.
Press the Auto button on the remote control to optimize the image signal.
This is used for assigning one of the following auto functions to the AUTO button on the controller.
We recommend pressing the AUTO button and setting the temperature to 22 °C(72 °F).
If you want to return in manual brightness adjustment(through the knob),press the AUTO button 5.
Press the AUTO button and you should see the 1 KHz reference signal. 2.
This setting assigns the SEQ, SORT, AUTO PAN or PATROL(PLAY)mode to the AUTO button on the controller.
Pressing the AUTO button activates the assigned function after this setting.
If PASSWORD LOCK is set to ON, you cannot operate AUTO PAN, SEQ, SORT, andPATROL even by pressing the AUTO button.
Press AUTO button again, holding it down until the AUTO light stops.
Otherwise, you can select AUTO Mode by pressing the AUTO button, and let the Particle Sensor control fan speed.
Press the AUTO Button(A) to perform an automatic optimised display setup.
Adjust this by repeating steps b- d above until all 6 periods are set for Monday or press the AUTO button to run the program as set, at any time.
Press AUTO button, holding it down until the AUTO light stops flashing.
AUTO button doesn't function The auto function is applicable only in VGA-Analog mode.
You may also press the AUTO button on the keypad or remote control to optimize.
Push the AUTO button to find a correct setting, or manually adjust the frequency until the vertical bands disappear.
To change the stored intensity level,press the AUTO button(5), so that its LED indicator is off, then manually adjust the light brightness to a desired level using the knob.
When the AUTO button is pressed, the background transition is executed automatically for the transition duration which has been set.
Press the AUTO button and the builtin heating program will start running.
Press out the AUTO button to experiment with manually controlled ATTACK and RELEASE times.
Push the AUTO button to find a correct setting, or manually adjust the frequency until the vertical bands disappear.
