Examples of using TALK button in English and their translations into Spanish
{-}
-
Colloquial
-
Official
To end a call,press the TALK button.
Press TALK button again to end communication.
The green LED lights up as long as the TALK button is pressed.
Press TALK button and dial number to make a call.
To answer an incoming call,press the TALK button on the BTM10.
Press TALK button momentarily, then communicate handsfree.
To answer a second call,press the TALK button for 1 second.
The TALK button lights up red when the phone is in use.
To reject a call,hold down the TALK button for 1 second.
The TALK button blinks green twice every 15 seconds in standby mode.
When the Boost function is enabled, the TALK button turns red.
When the TALK button is lit ORANGE volume may be at a high level.
After 12 hours of charging,lift the handset and press the TALK button.
Note: When you press the TALK button, you can no longer hear your baby.
If TALK button is pressed briefly(less than 0.5 second), communication ends.
During communication, press and hold TALK button for 1 second or more to change to press-to-talk mode.
If all PA zones are to be switched on andto be set to maximum volume while actuating the TALK button like button ALL CALL 6.
Hold down the TALK button until the red and green lights flash repeatedly.
While on a call,press the BOOST button to engage the additional amplification(up to 50dB); the TALK button turns red.
Press and hold the TALK button(B-1) and talk clearly into the microphone B-5.
For the chime to sound prior to an announcement when activating the TALK button, set the switch CHIME on the rear side to position ON downwards.
Hold down the TALK button on the microphone unit or the button on the device for approx. 2 seconds.
To verify, the phone's TALK button should no longer be orange when you are on a call.
When actuating the TALK button(52, 59, 68) on the microphone PA-4000PTT, PA-4300PTT or PA1120RC, a chime will precede an announcement.
For an announcement keep the TALK button(52, 59) pressed and wait for the chime, if required.
NOTE: The TALK button blinks(green) during the programming process; it will stop blinking when the programming process is complete at step 5.
To use voice dialing, press the TALK button and then complete your phone's voicedial procedure.
The red LED BUSY above the TALK button lights up when another PA-4300PTT with the switch MASTER/ SLAVE set to the position MASTER is used for making announcements.
To turn off the headset, press the TALK button until the red light flashes five times followed by two tones.
You end the call by pressing the TALK button on the microphone unit again or by pressing the button on the device.