Examples of using Clock sync in English and their translations into Spanish
{-}
-
Colloquial
-
Official
Clock sync with multiple standards.
The unit operates with clock sync.
Deactivate[RDS Clock Sync] before adjusting the.
B CLOCK indicator This shows the clock sync status.
When the clock sync setting is set to IN or MCK22M, this will begin to blink.
Subsequent docking long press CLOCK SYNC(5) to sync the clock. .
ESMA issues guidance on transaction reporting,order record keeping, and clock sync.
If you use NTP as well, clock sync issues should not occur.
Change the input connector used to receive a clock sync signal.
D CLOCK SYNC IN, 10MHz IN connectors Use these to input clock synchronization signals.
Lit: The unit is synchronized with the clock from the CLOCK SYNC input connector 10MHz IN.
E Clock sync input connector Used to input an external clock signal.
The indicator blinks when a signal is input through the CLOCK SYNC connector and stays lit when locked.
Check the clock sync input connector connection and the settings of the connected equipment.
When using a master clock generator,connect its clock output connector to this unit's CLOCK SYNC IN connector.
Check the connection of the CLOCK SYNC IN connector and the settings of the connected device.
When inputting a 10MHzoscillator sine wave signal, connect the output of the oscillator to this unit's CLOCK SYNC 10MHz IN connector.
Tektronix SPG8000- Clock, sync and test signal generation system.
On the standby mode, if you disconnect the iPhone/iPod and then you connect it to the unit again,it is necessary to long press the CLOCK SYNC button to achieve the clock sync function.
Check the connection of the CLOCK SYNC IN connector and the clock sync mode setting of the connected device.
During playback, when you connect the iPhone/iPod to the unit and switch to iPod mode andthen press and hold CLOCK SYNC button to make time auto changed synchronously with the connected iPhone.
Connect the clock sync input connector to the output connector of a master clock generator.
E If a cyclical humming noise is being output when using clock sync mode, the connected device might not be in clock sync mode.
This unit's master clock is synchronized to the clock signal(44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz, 176.4 kHz, 192 kHz or10 MHz) input through the CLOCK SYNC IN connector and used for operation.
The indicator blinks when a signal is input through the CLOCK SYNC IN connector, and it lights when the unit is locked to the signal.
Check the connections of the clock sync connectors and the clock sync setting of the connected device.
Set the sync clock on your MIDI device to“Internal.”.
Sync your clock with our time server.
Yeah, this new clock should sync up with the accelerator, theoretically.
