Examples of using Fault indicator in English and their translations into Spanish
{-}
-
Colloquial
-
Official
Unit Fault Indicator Red LED.
Something blew in the fault indicator.
The fault indicator is our master control.
Check the Site Wiring Fault Indicator.
The fault indicator will illuminate as solid red.
Battery mode, Bypass mode, and Fault indicators.
Site Wiring Fault Indicator for U Models.
Powerful Compact Full protection shutdown and fault indicators.
Short circuit fault indicator beside each port.
Fault indicator from and to the CVC 3000 vacuum controller.
On-board diagnostics enable the operator to verify fault indicators.
The fault indicator will illuminate as blinking red.
Check if the site wiring fault indicator lights up in LCD panel.
The Fault Indicators are normally OFF, but will blink under five different conditions.
LT3-SA: with automatic reset;voltage fault indicator light incorporated.
When the fault indicator illuminates red, WattStation is indicating a fault. .
When the machine is in fault, fault indicator will be on.
Site Wiring Fault Indicator for B40, B42, B44, and U Models.
The UPS operates normally, but the Site Wiring Fault indicator is lit.
It includes a fault indicator window and remote signal contacts.
Identify the faulty power supply by the power supply's fault indicator.
Voltage fault indicator light, device“test" and"reset" button incorporated.
After plugging in the loads and the UPS,check the site wiring fault indicator on the rear panel.
The storage module fault indicator seen from the front panel will be lit.
The LCD Alarm can be connected to a“Building Management System” for a generic alarm dry contact fault indicator.
Warning lamp Only the engine fault indicator calls attention to a fault. .
Identification of information display areas common to all modes(Fig. 3)- 2: Irrigation flow rate value.- 9:Operating fault indicator.
WARNING: If Digital Display shows“F02” and the Fault Indicator lights, the connection to the battery terminals is bad.
The site wiring fault indicator illuminates when the UPS is connected to an improperly wired AC power outlet.
Self-Monitoring Controller Console- includes a switch-selectable fail-safe alarm should the unit lose power, and a fault indicator for loss of communication with the sensor.