Examples of using Function selector in English and their translations into Spanish
{-}
-
Colloquial
-
Official
Switching off Switch off the function selector.
Rotate the function selector knob clockwise.
Turn the function selector to the TEST position.
To switch off the radio,press the bottom function selector again.
People also translate
Place the function selector to position.
If this is not the case,press the middle function selector(SET) two times.
Turn the function selector to the required position.
Setting the function with the function selector switch.
Now turn the function selector to HDG and adjust heading to 210.
For Datid OV7-- Set the function selector knob to F.
Slide the function selector to the radio position to turn the unit on.
For Framtid OV5-- Set the function selector knob to“0”.
Turn the function selector knob to the Broil position.
To chisel, turn the function selector switch 6 to.
Rotary function selector(chart/system-standard/channel-frequency)[6] Alphanumeric display[7] TUNE SELECT.
Oven blocked with the function selector in position“0”.
Set the Function Selector to MEMORY to enable independent memory functions. .
The settings of the Function Selector determines which source is heard.
Turn the function selector knob to the BROIL setting.
The settings of the Function Selector determines which source is heard.
Rotate function selector to 0 and fill the cup.
Rotate the Function Selector Knob(25) to Pre-Spray mode 25c.
A Rotary Key function selector switch is supplied together with SMB.
Move the middle function selector(SET) up or down to select the hour.
Use the function selector to select either VHF(except model D) or UHF.
Turn the function selector to 0 to exit the basic settings menu.
The settings of the Function Selector and the Tape Monitor Control determines which source is heard.
Slide the Function Selector to the OFF position to turn off power.
Turn the function selector to choose the maximum power microwave function. .