Examples of using Minimum section in English and their translations into Spanish
{-}
-
Colloquial
-
Official
Minimum section for cutting: 50mm(every 3 LED lights).
We recommend to use a minimum section of 4mm2 for each conductor.
Minimum section of fixed wiring must be of 1,0 mm.
The welding coiled capillary tube is presented in minimum sections of 5000 feet.
The minimum section is specified in the table below.
This projector must be connected to a power supply cable with a minimum section of 2x1mm².
Check the minimum section of the individual cables using extensions.
The electric wires of your residence shall be of copper and have minimum sections of 2.5 mm2.
The minimum section is 1.5 mm², but it can be increased according to the installation requirements.
We recommend using suitable cables see Fig.28 for minimum sections to be used.
The extension cord must have a minimum section of 1 mm2 and must be supplied with a three-pole plug/socket.
Maximum cable length Up to 20 m observe warnings regarding the minimum section and type of cables.
Using extensions, check the minimum section of the individual cables see paragraph entitled“Connection to the mains appliances”.
Ground> terminal Connecting cables can be up to 500 meters long with a minimum section of 0,5 mm2.
When using a cable extension, make sure it has a minimum section of 1,5mm, no longer than 25 metres in length and ensure it is adequate for outdoor use.
If for any reason the supplied cable is not to be used or if it is not long enough, a 2-pin twisted shielded cable,category 5, with a minimum section of 0.5 mm2 must be used.
When using a cable extension, make sure that its minimum section is 1.5mm2 and no longer than 25 metres, always unrolled and adequate for outdoor use.
The minimum section must be 4 dm2(for example 20x20 cm) for appliances whose pipe dimensions are less than 200 mm, or 6.25 dm2(for example 25x25 cm) for appliances with a diameter of more than 200 mm.
The quality of the extension leads must be no less than H07RN-F or H07VV-F, with a minimum section of 1.5 mm2 and a recommended maximum length of 25.
These metal columns were designed with a minimum section, in order to integrate them and disappear aligned with the openings of anodized aluminum.
It can be installed in different rooms of the house as long as the room is sufficiently well ventilated it must have large enough air inlet andan efficient air outlet with a minimum section of 50 for each orifice.
For the loudspeaker connections, twin conductor cable with a minimum section of 4 mm should be used, or even greater if the distance between amplifier and loudspeaker exceeds 20 m.
Must be protected by grates, metal net orsuitable protections as long as they do not reduce the minimum section stated in point 1 and positioned in order to avoid them being obstructed.
The power cable must meet the minimum standards of H07 RN-F and have a minimum section of 5x1.5 mm2; it must not be installed near heat sources and the temperature of the place in which the appliance is installed must not rise above 50 C.
I Minimum straight section between two adjacent elbows: 100mm.
Note 1: highlighted cable cross sections: minimum cross section due to thermal limit.
Make sure that the minimum cross section on the chimney is large enough.