Check remote connections at amplifier and source unit.
Compruebe las conexiones remotas en el amplificador y en la unidad fuente.
Ÿ The source unit volume may be set too high.
Ÿ El volumen de la unidad fuente puede estar demasiado alto.
Turn the balance control of the source unit to its center position.
Fije el control de balance de la unidad fuente en su posición central.
Set the source unit volume to 3/4 of full volume.
Ajuste el volumen de la unidad fuente a 3/4 del volumen máximo.
This wide adjustment range accommodates virtually any source unit brand.
Este rango de ajuste ancho da cabida a prácticamente cualquier marca de unidad fuente.
Once you set the source unit volume, do not change it.
Una vez ajustado el volumen de la unidad fuente, no lo cambie.
Press and hold the Menu button(volume knob)until RF AMP DSP/ FOR SETUP MENU appears on the source unit display.
Presione y mantenga presionado el botón Menu(perilla de volumen) hasta queaparezca RF AMP DSP/ FOR SETUP MENU en la pantalla de la unidad fuente.
The projector's light source unit uses a laser and LED.
Launidad de la fuentede luz del proyector utiliza un láser y un LED.
If your source unit does not have a dedicated Remote Turn-on lead, you may connect to the source unit's Power Antenna lead.
Si tu autoradio no tiene una salida para el control remoto, lo puedes conectar a la antena.
Connect RCA input from test source unit directly to amplifier input.
Conecte la entrada RCA de la unidad fuentede prueba directamente a la entrada del amplificador.
Wiring: The KXM amplifi er's RCA inputs will receive either high or low level signals from your car stereo's source unit.
Cableado: Las entradas RCA del amplifi cador KXM recibirán señales de alto o bajo nivel desde la unidad fuente del estéreo de su automóvil.
Connect RCA cables from your source unit to your MTX XTHUNDER amplifier's RCA input jacks.
Conecta los cables RCA de tu autoradio a las entradas de RCA de tu amplificador MTX XTHUNDER.
Connect the AUX INPUT to the external audio source this inserts the audio before the volume control on the source unit.
Conecte el AUX INPUT a la fuente externa de audio eso inserta el audio antes del control de volumen en la unidad fuente.
Mounting the source unit in the center console provides optimum access.
El montaje de la unidad fuente en el panel de instrumentos ofrece acceso óptimo.
Set the volume control of the source unit to approximately 2⁄.
Fije el control de volumen de la unidad fuente a aproximadamente 2/3 de su máximo de salida.
Input Gain The Orion Cobalt CO3002 andCO6002 amplifiers have level adjustments to allow for easy integration with any source unit.
Amplificación de entrada Los amplificadoresOrion Cobalt CO3002 y CO6002 tienen ajustes de nivel para facilitar la integración con cualquier unidad fuente.
Connect a Remote Turn-on wire from your source unit to your Xtant amplifier's REM terminal 14 or 16 gauge wire.
Conecte un cable de encendido a distancia desde la unidad fuente hasta el terminal REM del amplificador Xtant cable calibre 14 ó 16.
If RCA(low level) output is not available, connect the included speaker(high level)connector to the speaker wires from the source unit.
Si la salida del RCA(bajo nivel) no está disponible, usa el conector(alto nivel) de los altavoces(incluido)para conectarlo a los cables del autoradio.
When using the Optical Input,make sure the source unit the cable is plugged into is in Digital PCM(2 Channel) Mode.
Cuando se utilice la entrada óptica,compruebe que el cable de la unidad fuente esté conectado en el modo PCM digital 2 canales.
Connect the AUX(1) and AUX(2)INPUTS to a external audio source this inserts the audio before the volume control on the source unit.
Conecte las ENTRADAS AUX(1) y AUX(2)a una fuente de sonido externa esto inserta el sonido antes del control de volumen en la unidad fuente.
The QS coaxials are rated at 4 ohms and work with any source unit or amplifier designed to operate at a 4 ohm load.
Los coaxial QS están clasificados para 4 ohms y funcionan con cualquier unidad fuente o amplificador diseñado para operar a una carga de 4 ohms.
Connect the high level inputs(speaker) from the source unit into the matching connections of the connector for the 3Sixty High Level Input.
Conecte las entradas de alto nivel(altavoces) de la unidad fuente a las conexiones coincidentes del conector para la entrada de alto nivel del 3Sixty.
You can transfer Title/Frame Images you created on the PC to the video source unit that is packaged with MultiMediaNavigator.
Puede transferir imágenes título/marco que usted creó en el PC para la unidad fuente de video que está empacado con el MultiMediaNavigator.
If the amplifier is connected to the source unit with the remote(REM) wire, the amplifier will power on when the source unit is turned on.
Si el amplificador está conectado a la unidad fuente con el cable remoto(REM), el amplificador se encenderá cuando se encienda la unidad fuente.
The RS components are rated at 4 ohms and work with any source unit or amplifi er designed to operate at a 4 ohm load.
Los componentes RS están clasifi cados para 4 ohms y funcionan con cualquier unidad fuente o amplifi cador diseñado para operar a una carga de 4 ohms.
Results: 339,
Time: 0.0436
How to use "source unit" in an English sentence
Turn the source unit volume down.
Source unit has no output Check that your source unit is functioning properly.
The source unit may contain several classes.
Is the source unit name case sensitive?
NOTE: After the source unit is on.
Marine source unit with easily readable screen.
Light error: Light source unit error occurred.
Source unit from Alpine with iPod connection.
Tool 4000 electronic flasher 5500xl source unit lathe.
Fusion CA-ML450 Mechless Stereo Source Unit User Manual..
Español
Dansk
Deutsch
Français
हिंदी
Italiano
Nederlands
Português
Русский
Tagalog
عربى
Български
বাংলা
Český
Ελληνικά
Suomi
עִברִית
Hrvatski
Magyar
Bahasa indonesia
日本語
Қазақ
한국어
മലയാളം
मराठी
Bahasa malay
Norsk
Polski
Română
Slovenský
Slovenski
Српски
Svenska
தமிழ்
తెలుగు
ไทย
Turkce
Українська
اردو
Tiếng việt
中文