Examples of using Stud sensor in English and their translations into Spanish
{-}
-
Colloquial
-
Official
A stud sensor is optional.
Following proper calibration of the stud sensor 5.0.
Hold stud sensor straight up and down.
You can free download PDF manuals for 4105 Sierra Monitor Corporation Stud Sensor.
Use the stud sensor only with AAA batteries.
You can add another document for the device Contec CONTECH CS2000 Stud Sensor.
Stud sensor turned on over a stud. .
Run through the calibration technique described earlier WITH the piece of cardboard between the stud sensor and the surface.
Remove the stud sensor/level as shown in figure C.
The stud sensor/level can only be inserted in one direction.
Do not operate the stud sensor in explosive atmospheres, such as in the presence of.
Place stud sensor on wall as shown in figure 1.
Do not operate the stud sensor in explosive atmospheres, such as in the presence of.
The stud sensor can locate wood or metal studs and joists and live AC wiring.
Using an electronic stud sensor, locate a wall stud at your desired mounting location.
Place the stud sensor/level back into the two foot(610 mm) level for storage.
Use the stud sensor only with 9 volt alkaline battery.
Use the stud sensor only with the specifically designated.
Note: the stud sensor cannot be used with the spacer insert fitted.