Examples of using The memory module in English and their translations into Spanish
{-}
-
Colloquial
-
Official
Handle the memory module with care.
Removing and Installing the Memory Module Cover.
Insert the memory module into the slot and press it down.
If you do not hear the click,remove the memory module and reinstall it.
Remove the memory module as shown in Fig 1.
You should not touch the connectors or open the memory module compartment cover.
Hold the memory module by its notches and remove it from the slot.
Notches also help ensure that the memory module is installed correctly.
Hold the memory module by its notches and remove it from the slot.
Is the connection part between the memory module and the memory slot.
The memory module configuration for each processor must be identical.
Press the ejectors on the memory module socket down and out.
The memory module BMC-M-CFI-01 is for downloading and uploading of projects on the PLC.
Generally, the larger the memory module, the more expensive it is.
Press the memory into the socket until the tabs snap into place and secure the memory module.
Hold the memory module by its notches and remove it from the slot.
This section describes the procedure to install the memory module on a PERC x/E Adapter.
Do not open the memory module package before you are ready to change the module. .
In case of failure of the radio receiver built in the control panel, the remote control codes can be accessed by extracting the memory module.
Do not remove the memory module while the computer is in Sleep or Hibernation mode.
Note: Never apply pressure or handle the memory module on or around the Integrated Circuit(IC)!
Hold the memory module by its notches, but do not touch the gold connectors.
Verifying the Expanded Memory To verify that the memory module is working properly, test it by printing a status page.
Slide the memory module into the slot at a(approximately) 45-degree angle.
If the computer starts normally,move the memory module to a different connector and restart the computer.
The memory module is mounted flush with the board so that the memory module is parallel to the board when installed.
Important: Hold the memory module by its edges, and do not touch the gold connectors.
Removing the Memory Module To remove a memory module, remove the right cover and the memory slot cover from the machine.
Now, push the memory module in place, and the plastic edges will snap closed on their own.