Examples of using Electrical conductivity in English and their translations into Turkish
{-}
-
Colloquial
-
Ecclesiastic
-
Ecclesiastic
-
Computer
-
Programming
Primary factors usually include high electrical conductivity, and low density.
The good electrical conductivity of plasmas makes their electric fields very small.
Often this is stated as:full bands do not contribute to the electrical conductivity.
The two developed the electrical conductivity of polyacetylene along with American physicist Alan Heeger.
In addition,an advantage of graphene over activated carbon is its higher electrical conductivity.
Electrical conductivity of water is directly related to the concentration of dissolved ionized solids in the water.
Dissolved ionized solids, such as salts and minerals, increase the electrical conductivity(EC) of a solution.
Fluids that have low electrical conductivity(below 50 picosiemens per meter), are called accumulators.
Such"sigma-bonding electrons" have low mobility anddo not contribute to the electrical conductivity of the material.
However, unlike electrical conductivity, the thermal conductivity of a metal is nearly independent of temperature.
To this end, research to increase surface area, mechanical strength, electrical conductivity and chemical stability is ongoing.
Thus a fluid that has an electrical conductivity of 1 pS/m has an estimated relaxation time of about 18 seconds.
Alteration of water's physical chemistry includes acidity(change in pH), electrical conductivity, temperature, and eutrophication.
This one shows the electrical conductivity of the skin in the palm of the hand- a measure of perspiration, which increases under stress.
When light is absorbed by a material such as a semiconductor, thenumber of free electrons and electron holes increases and raises its electrical conductivity.
They can offer high electrical conductivity but do not show similar mechanical properties to other commercially available polymers.
Therefore, undoped conjugated polymers, such as polythiophenes,polyacetylenes only have a low electrical conductivity of around 10-10 to 10-8 S/cm.
Even at a very low level of doping(< 1%), electrical conductivity increases several orders of magnitude up to values of around 0.1 S/cm.
Electrical conductivity or specific conductance is the reciprocal of electrical resistivity, and measures a material's ability to conduct an electric current.
Hydrogen's electron and proton are not bound together,resulting in very high electrical conductivity and high emissivity producing the light from the Sun and other stars.
When electrical conductivity of ICN is compared with that of iodine-pyridine solutions, the formation of the electrolyte in ICN proceeds much more slowly.
Even a partially ionized gas in which as little as 1% of the particlesare ionized can have the characteristics of a plasma i.e., response to magnetic fields and high electrical conductivity.
For fluids with electrical conductivity below 10 pS/m, bonding and earthing are not adequate for charge dissipation, and anti-static additives may be required.
These fields are typically weak(about few micro-Gauss), but they can get anchored to the matter in the disk,because of its high electrical conductivity, and carried inward toward the central star.
The lower electrical conductivity of organic solvents(10 to 60 mS/cm) leads to a lower specific power, but since the specific energy increases with the square of the voltage, a higher specific energy.
Auto reignition is a safety feature thatis used in some flame igniters that senses the electrical conductivity of the flame and uses this information to determine whether a burner flame is lit.
According to the proponents of this technology, problems associated with this design include:Poor electrical conductivity Range of concept design is minimal(a gas cannot be propelled greater than 3 metres(9.8 ft) effectively) The"gassing effect": all subjects in enclosed spaces are subjected to the same effects Since 2001, Russian developer Oleg Nemtyshkin has sought to create a repeating stun pistol.
Calculation==SAR for electromagnetic energy can be calculated from the electric field within the tissue as: :formula_1where:formula_2 is the sample electrical conductivity: formula_3 is the RMS electric field: formula_4 is the sample densitySAR measures exposure to fields between 100 kHz and 10 GHz generally known as radio waves.
The German physicist Johann Wilhelm Hittorf studied electrical conductivity in rarefied gases: in 1869, he discovered a glow emitted from the cathode that increased in size with decrease in gas pressure.
In metals, thermal conductivity approximately tracks electrical conductivity according to the Wiedemann-Franz law, as freely moving valence electrons transfer not only electric current but also heat energy.