Examples of using Leds in English and their translations into Urdu
{-}
-
Ecclesiastic
-
Colloquial
-
Computer
The Atlantik V2 1 LEDs.
LEDs and Clock Display.
Provides enough RED and IR LEDs needed.
All LEDs are five watt dual diode LEDs.
Illumination 1 controls 24 blue 460nm LEDs.
People also translate
Don't look directly at the LEDs when the unit is plugged in.
That is when he decided to change to LEDs.
LEDs- 40 pieces of three watt high efficiency Power LEDs.
The previous lighting ran with two screens of LEDs.
The motherboard leds are all run single connector but will unable.
What is noticeable here is the high cyan range andthe various UV LEDs.
The LEDs are the same high quality LEDs used in the PR156.
Orphek uses full spectrum white LEDs and at any Kelvin desired.
High power LEDs tuned to the PUR spectrum to provide excellent coral and clam growth.
The second timer controls the remaining four actinic LEDs and is used as a night time/moonlight feature.
LEDs are bright but without quality diodes or the right optics for your setup some won't penetrate much useful light past the first few inches of water.
Safe high range UV and our special Orphek red LEDs installed which will give your corals and fish pop out color.
LEDs generate very little heat, and a much higher percentage of the electrical power is going directly to generating light which drops electricity demands considerably.
It is understandable why some companies use the Cree LEDs and it's because of their high lumens per watt ratio.
With LEDs, we cannot waste energy providing unneeded wavelengths, but focus our energy in the needed spectrum which falls between 400-550nm and 620-700nm.
Is their spectrograph highin reds and yellows, do they use green LEDs for effect which have no real benefit for growing coral.
Because of the quality of LEDs used in all Orphek fixtures, diode failure is nearly non-existent.
De who ran un experiment using the premises of Emerson anda combination of 2 Orphek 850 Nm Leds(5 watt) and 1 Orphek wide Red(5watt).
This luminaire contains 4 LEDs producing UV radiation with peaks at 382, 383, and two at 384 nm.
These units arefitted with the proper connectors which will allow the LEDs to be controlled by either of the above controller's external hardware.
Clusters of red, green, and blue LEDs are grouped on the panel, creating the full-color pixels needed to produce an image.
Excessive use of green and yellow LEDs can have negative reactions with some corals and give false PAR/PUR readings.
The Atlantik V4 has, with its 78 dual chip leds placed next to each other, the biggest spread of them all and also the biggest range in different leds.
The Orphek PR156 uses three watt LEDs but runs them at two watts to reduce heat and provide better longevity for the LEDs.
Orphek uses proprietary 16K white LEDs to increase the PUR value and reduce the amount of blue LEDs which have a very low Lumens per watt ratio.
