Examples of using A density in English and their translations into Vietnamese
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
It is limited to concrete having a density in excess of 800 kg/m3[50 lb/ft3].
The system analyzes each pixel and uses areas of 100percent fatty tissue as a baseline to build a density map.
As can be observed on the chart, the article has a density of 2.11% for the word“keywords” and a density of 1.46% for the word“keyword”.
Making the balls heavier and smaller increases the stroke distance, so it is obvious that normal golf balls go to these limits andtherefore will have a density of about 1.09 as they will sink in water.
This process creates a solid product with a density over 90% of the specific density of this metal.
People also translate
Balsa wood has a density of 40 kg/ m3(lighter than water!) But it is very strong because of the natural structure of cellulose and lignin fibers.
However, the most construction use is for theproduction of autoclaved aerated concrete bricks with a density of about 110kg for one cubic meter of bricks.
Oils, other than crude oils, having a density at 15°C higher than 900 kg/m3 or a kinematic viscosity at 50°C higher than 180 mm2/s; or.
Contrast that with Toshiba's current highest capacity drive today,which is based on existing technology and has a density of 541 gigabits per square inch or about one fifth that of the new technology.
This implies that this planet has a density of 96% that of water, and surface gravity 1.93 times that of Earth.[3] A search for rings and satellites around this planet with the Spitzer space telescope was negative.
It adapts to all types of work(insulation of walls, roofs, eaves, exterior…)and has a long life but a density, so a mass, which varies greatly and can be important.
For fluids, the reference substance is usually the water, with a density of 1.00 x 103 kg/m3 at 4 degrees Celsius(water's densest temperature), used to determine whether or not the fluid will sink or float in water.
The wall channel section placed between the lower and the upper air channels is made of steel plates and non-combustible fibre reinforced calcium silicateboards with a thickness of 11± 2 mm and a density of 680± 50 kg/m3.
If the density decreased linearly with increasing radius from a density ρ0 at the center to ρ1 at the surface, then ρ(r)= ρ0-(ρ0- ρ1) r/ re, and the dependence would be.
Thus, the planet has a density of 1.68 grams per cubic centimeter, similar to that of Neptune(1.638 g/cm3).[1] The planet's equilibrium temperature is estimated to be 1620 K, thirteen times hotter than Jupiter's equilibrium temperature.[2].
With a salinity of 342 g/kg, or 34.2%, it is one of the world's saltiest bodies of water- 9.6 times as salty as the ocean-and has a density of 1.24 kg/litre, which makes swimming similar to floating.
It is sold under the trade name Visipaque;it is also sold as a density gradient medium under the name OptiPrep.[1] Visipaque is commonly used as a contrast agent during coronary angiography.
The arrangement of the carbon atoms also allows heat to move steadily through the tube, which gives it around 15 times the thermal conductivity and 1,000 times the current capacity of copper,while maintaining a density that's just half that of aluminium.
Flame retardant MDF is made of wood fiber or other plant fiber and urea formaldehyde resin or other suitable adhesive is applied In the spray section as with sizing a flame retardant is added to theproduction line to form a sheet having a density in the range of 500 to 880 kg m3 Flame retardant MDF has good physical….
Fan manufacturers define standard air as clean,dry air with a density of 0.075 pounds mass per cubic foot(1.2 kg/m³), with the barometric pressure at sea level of 29.92 inches of mercury(101.325 kPa) and a temperature of 70 °F(21 °C).
Combined with a carefully optimized sequence of so-called Raman cooling(first demonstrated by Chu and Kasevich),this allowed us to produce a cold cloud of atoms with a density high enough to create a moderately sized BEC in about one second of cooling.".
At standard temperature and pressure,radon forms a monatomic gas with a density of 9.73 kg/m3,[4] about 8 times the surface density of the Earth's atmosphere, 1.217 kg/m3,[5] and is one of the heaviest gases at room temperature and the heaviest of the noble gases, excluding ununoctium.
Gold is one of the most valuable and sought-after metals in the world,it has a melting point of 1,064°C, a density of 19.3 g/cc, and a vapor pressure of 10-4 Torr at 1,132°C with its ideal evaporation temperature being around 1,400°C.
The term"mega-Earth" was coined in 2014,when Kepler-10c was revealed to be a Neptune-mass planet with a density considerably greater than that of Earth.[1][2] However, it has since been determined to be a typical volatile-rich planet.[3].
Europa is thought to have a subsurface ocean False-color image of Ganymede Callistoshowing frost deposits Mimas has a density of 1.1 g/cm3 Active plumes on Enceladus Titan showing surface and atmospheric details Miranda has a scarred surface A potential frost deposit on Umbriel's pole A cloud over the limb of Triton.
In Warsaw, the Jews, comprising 30% of the city overall population,were forced to live in 2.4% of the city's area, a density of 7.2 people per room.[2] In the ghetto of Odrzywół, 700 people lived in an area previously occupied by five families, between 12 and 30 to each room.
The nebula holds about 0.13 solar masses of matter, including hydrogen, helium, nitrogen, oxygen,and sulfur;[1] all with a density of less than 100 particles per cubic centimeter.[2] Its outer radius is around 0.91 ly(0.28 pc) and it is expanding with velocities in the range of 27- 39 km/s into the surrounding interstellar medium.[4].
Europa is thought to have a subsurface ocean False-color image of Ganymede Callistoshowing frost deposits Mimas has a density of 1.1 g/cm3 Active plumes on Enceladus Titan showing surface and atmospheric details Miranda has a scarred surface A potential frost deposit on Umbriel's pole A cloud over the limb of Triton.
