Examples of using Meter sensor in English and their translations into Vietnamese
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
Turbine flow meter sensor size.
Electrodes material of magnetic flow meter sensor.
Flow meter sensor material: 316L sst.
No moving parts inside flow meter sensor.
The turbine flow meter sensor or overhead transmission cable can be buried.
No strict straight pipelines requirement before and after the flow meter sensor.
The max level this type level meter sensor can detect is 70m;
Large flow meter sensor size available, such as DN 2000mm mag meter. .
Do you need special materials, such as flow meter sensors that require 316 stainless steel?
Mag meter sensor has not moving parts, easy maintenance and longer serving time.
And the idea situation is that the flow meter sensor size is the same as the pipe size.
Magnetic Flow meter sensor is widely used to measure different kind conductive liquids.
The water temperature is high,so the water flow meter sensor should bear temp. around 150℃(302℉).
Ultrasonic level meter sensors are applicable in many types of applications including rainwater basins, wet wells, and wastewater chemicals.
The Thermal dispersion gas flow meter can measure low flow rate and low flow gas,and the flow meter sensor also has high sensitivity signal.
Micro gear driven flow meter sensor size is 2mm, can detect oil flow as low as 0.5 ml/min.
Methane gas flow meter2019/05/24Thermal mass flow meter is a kind of electronic mass flow meter sensor for methane/biogas flow rate measurement.
Whether the mag flow meter sensor is grounded or not is directly related to the accuracy and stability of the flow measurement.
Turbine flow meter is a kind of low price cost and economical solvent flow meter, the rotor in the turbine flow meter sensor is suspended by a bearings which gives it nearly no drag coefficient.
The flow meter sensor must be in the center of the pipe due to the highest flow of velocity flow which will be detected the furthest away from the pipe walls.
If the inner lining material of the electromagnetic flow meter sensor is PTFE, a ground ring should be used to protect the flanged of PTFE from damage.
When the magnetic flow meter sensor is installed on the plastic pipe or the pipe with insulating paint or paint, the two ends of the mag flow sensor should be installed with ground wire, so that the measured medium in the pipe and the earth short circuit have zero potential, otherwise the electromagnetic flow transmitters cannot work normally.
Coriolis flow meter is bulky and large, and obviously,DN6 flow meter sensor size is cheaper than 4 inch coriolis flow meter, normally the large size, and the higher price.
Variable flow meter sensor options, from DN3 to DN2000, micro low flow water flow meter or large pipeline water flow meter. .
Thermal mass flow meter digital display can show gas temperature value upon request,it can even output dual 4-20mA outputs from the flow meter sensor, one is gas flow information, another is Temperature probe RTD signal.
The flow signal generated by the mag meter sensor is very small and only a few millivolts at full range, so the sensor should be well grounded.
Advantage of the magnetic flowmeter including low pressure loss, no moving parts inside flow sensor, suitable for large pipe flow meter sensor, high accuracy, can work on aggressive and corrosive liquid.
A dedicated DIGIC 8 processor has been employed for AF management andcontrol of the 400,000 pixel RGB+IR metering sensor.
Assisting with the capture of properlyexposed images is a 7560-pixel RGB+IR metering sensor that helps minimize the impact of flickering lights in your images and ensures accurate reading of the entire scene.
In addition, the high resolution of the metering sensor with its roughly 91,000 pixels enables extremely precise analysis of the scene for more accurate control over auto-focusing, auto exposure, i-TTL flash control, and auto white balance.