Voorbeelden van het gebruik van A scsi in het Engels en hun vertalingen in het Nederlands
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Computer
-
Ecclesiastic
-
Official/political
-
Programming
In case of a scsi cd-rom this is.
This refers to a discontinuity in a SCSI bus.
Iomega markets a SCSI host adapter under the name ZIP Zoom.
You can choose from a DT or a SCSI Virtual Drive.
If you have a SCSI card you must of course select the options that you need.
Mensen vertalen ook
The Commodore A 2091 with a SCSI hard disk installed.
Your BIOS may not allow you to boot directly to a SCSI drive.
Conf files, one for a SCSI/IDE and another for an IDE/IDE system.
I have done this mainly for the performance gains in using a SCSI drive.
I guess I would have to change that if I use a SCSI card instead of the parallel port adapter.
the connected hard disk must be a SCSI type.
DVD-RAM writers can use either a SCSI or ATAPI interface.
Sometimes, a SCSI CDROM may be missed because it did not have enough time to answer the bus reset.
DAEMON Tools Pro is a virtual DVD-ROM emulator based on a SCSI miniport driver.
If you have a SCSI CD burner chances are very good that your burner is immediately recognized by the kernel.
However if you incur any data loss scenario on a SCSI drive you can recover data easily using Remo Recover.
They have a scsi interface that can be used to log data at really high speed,
and it is a SCSI CD-ROM, the installation program prompts you to choose a SCSI driver.
I added a SCSI controller and drive,
In general, you cannot have kerneld load a driver for a SCSI host adapter, if a driver for another host adapter is already installed.
While in a SCSI bus a device can be dumping data to the bus while another is retrieving it,
Linux has a software iSCSI initiator in the kernel that takes the place and form of a SCSI HBA driver
If you have a SCSI CDROM please add the following option to your kernel configuration
For an ATAPI/IDE burner you have to configure SCSI emulation to make your burner look like a SCSI device even though the hardware is physically connected via the IDE bus.
For example DKA100 refers to a SCSI disk with SCSI target ID 1 on the first SCSI bus(A), whereas DKC300 refers to a SCSI disk with SCSI ID 3 on the third SCSI bus C.
there is probably a SCSI controller that is not being recognized by the installation program.
enough to have a SCSI adapter, you probably already know this,
This was a SCSI disk with AHA2940UW controller which uses either H=64,
so if you have a SCSI or IDE controller,
