Voorbeelden van het gebruik van Capacitive load in het Engels en hun vertalingen in het Nederlands
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Computer
-
Ecclesiastic
-
Official/political
-
Programming
For capacitive load, derate current by 20%.
Conventional transformers and capacitive loads e.g.
When the capacitive load is large,
Discharge rate for capacitive load 1.5 s/μF.
That means you can dim resistive, inductive and capacitive loads.
Charging rate for capacitive load 5 seconds per μF.
Seconds per Discharge rate for capacitive load.
Not suitable for capacitive loads eg. led drivers.
Switching contacts are not suitable for capacitive loads.
D inductive and capacitive loads like transformers, condensers,….
The switching contacts are optimised for capacitive loads.
Mico Pro identifies capacitive loads and starts them up in a controlled way.
Switching contacts are not suitable for capacitive loads. Approvals.
The large capacitive load at the output is probably the cause of this.
So it's possible to monitor a number of high capacitive loads with one device.
Inductive or capacitive load could not exceed 40% of the rated current.
Observe the safety measures when working with inductive or capacitive loads.
Outputs are stable with capacitive loads of over 500 pF.
This uses a series output resistor to achieve isolation of the capacitive load.
Resistive, Inductive and Capacitive load three in one, switchable.
even with a capacitive load.
Resistive, inductive and capacitive load(three in one) it can be transformed. 8.
inductive load, for capacitive load current derate by 20%.
Not suitable for Capacitive load, as electric motor,
The most important features of this special circuit are that it can handle complex capacitive loads very well and its small output impedance.
DP50V5A output for battery charging or capacitive load, please add a diode on output positive
The C-type dimmers are used for C-type loads(electronic transformers, to be considered as a capacitive load) and use the reverse phase-cut principle.
When an insulation resistance like a capacitive load is measured,
with some inductive loads, but effect for load using life, because capacitive loads and inductive loads need high quality power.
But if it is inductive loads and capacitive loads, we recommend using pure sine wave power inverter.