Voorbeelden van het gebruik van Set values in het Engels en hun vertalingen in het Nederlands
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Computer
-
Ecclesiastic
-
Official/political
-
Programming
Set Values.
It can show the set values and operation time.
Set values max, min, diff.
It can show the set values and operative time.
Set values are shown on the display.
Mensen vertalen ook
If the log does not require calculation of partitions, set values 0.
The set values are stored in a sorting program.
If the measured values deviate from the set values, your air conditioning system is recalibrated.
Set values and create your original highlight footage.
how to use and set values.
The set values vary depending on the encryption level.
Torque tools can only be used effectively and reliably if the set values are applied correctly.
Set values for the mail settings listed below,
Column width from Set values section.
Set values for the network settings listed below,
this is a signal generator where the frequency is constant varying between two set values.
When the set values are exceeded the alarm will sound.
calculates the percentage of oxygen in the blood on the basis of the set values.
Specifies set values for the marquee's height and width.
After the door is opened, only a short recovery time is required for the climate in the constant climate chamber to return automatically to the previously set values.
The Member States must set values no less stringent than the I values,
in particular the chapters"Choice of Program" and"Set values.
In the event of deviation from the set values, the system sends an alert directly to a Boels technician who can take immediate action if required.
you must read the operating manual- in particular the chapters"Program selection" and"Set values.
The frequency is constant varying between two set values, on the oscilloscope screen you get a frequency spectrum with the response curve of the two circuits.
then specify row height and column width in the set values section successively, and click the OK button.
For example, to boot the installer and set values for the"io" and"irq" options for the parport_pc module, enter the following at the boot prompt.
However, these set values are to be only temporary because,
If the speed exceeds the set value, the relay switches off.
The Timer shows the set value(30 minutes).