Voorbeelden van het gebruik van Starting current in het Engels en hun vertalingen in het Nederlands
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Computer
-
Ecclesiastic
-
Official/political
-
Programming
Starting current:< =700MA.
CA 100-2000 0℃ when the effective starting current rating.
Starting current: 1200mA(start the moment).
Wide range measurement from starting current to maximum current. .
The starting current can also be measured.
MCA 100-2000 ships standard effective starting current rating, 0℃.
Higher starting current for motor application 4.
In addition, the customer was having difficulties managing the system's starting current.
Very low starting current in the electric supply.
Best price NSYCRS25W240V Climasys Ultra thin resistance heater low starting current 20W 240V 130x250mm.
The starting current is too small(less than 2 times).
The effect is to increase the starting current and increase the initial torque.
Starting current(the higher the current, the better).
The torque control means the starting current is reduced even further by up to 30%.
The starting current can reach 2C,
With additional functions for starting current, output and measurement in the μA range.
Starting current in the electric supply stays below the nominal current of the motor.
Offers better reduction of starting current than traditional star/delta starter.
In addition, inverter technology is more friendly for power grid soft start and lower starting current.
A higher starting current guarantees a smoother start. .
Install a reliable battery with a strong starting current, use only serviceable candles.
The starting current is a maximum of 1.2 times the nominal current. .
Climasys Ultra thin resistance heater low starting current 12W 120V 130x250mm View Details Best price.
Low starting current at start, no or marginal higher than nominal current. .
Climasys Ultra thin resistance heater low starting current 12W 120V 130x250mm View Details Add to….
Very low starting current and high power factor(even at partial loads).
A typical starting current ranges from 50 to 160 amperes per digital ballast.
Overcurrent protection: refers to a protection device whose starting current is set according to the maximum load current. .
the design of which provides for the restriction index starting current.