Voorbeelden van het gebruik van The ammeter in het Engels en hun vertalingen in het Nederlands
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Computer
-
Ecclesiastic
-
Official/political
-
Programming
Please do not use the ammeter if the back cover is wrong.
I is the current strength measured by the ammeter, A.
Please do not use the ammeter if the back cover is wrong.
Caliber called the highest intensity that can measure the ammeter.
Please do not use the ammeter if the back cover is wrong.
Please do not change the inner circuit to avlod damaging the ammeter.
The ammeter is then short circuited
This voltage is equal to the source voltage minus the voltage drop across the ammeter.
The ammeter ferro-magnetic(or ferromagnetic)
you will see the current will flow on the ammeter. You will still rotate round, cos the jet's still running.
At this point, the ammeter suddenly shows no indication
you will see the current will flow on the ammeter. You will still rotate round, cos the jet's still running.
The ammeter can only be connected to the negative of the device under test
This means that the electrical conductor around which the flexible current clamp is placed induces a voltage in the ammeter.
Therefore, the ammeter connected to the secondary coil has an indication-the current of the circuit under test is measured.
This means that it must open the circuit at the place where you want to measure the intensity and put the ammeter between the two terminals created by the opening of the circuit11.
It is the ammeter of the X-rays device[Diana]
for example cutting current or bypassing the ammeter during the change of calibre of the device,
Connect the ammeter in series with the LED to measure the current through it,
We check while terminal+ of the ammeter is connected(possibly through one or more dipoles) at the pole+ of the generator and that the Terminal- the ammeter is connected(possibly through one
Contains the voltmeter, ammeter, power meter,
This time, it is therefore literally a cable which integrates the voltmeter and ammeter!
Should be located in the execution room for monitoring. The voltmeter, ammeter, and switchboard controlling the current.
Furthermore the clamp-on ammeter has got a continuity tester, and a diode tester.
At this time, the value displayed by the voltmeter and ammeter is 75.
For the digital clamp-type ammeter, Also check the battery level of the battery is sufficient.
When using a high-voltage clamp meter, pay attention to the voltage level of the clamp-type ammeter.