Voorbeelden van het gebruik van The terminal block in het Engels en hun vertalingen in het Nederlands
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Computer
-
Ecclesiastic
-
Official/political
-
Programming
The terminal block with big space for wiring.
Easy access to both sides of the terminal blocks.
The terminal blocks can be combined with 3P and 2P.
Step 4 Remove the plastic covers from the terminal block.
Faceplate over the terminal block in metallised aluminium.
Reverse polarity protection at the terminal block input.
Alternatively, the terminal blocks can be snapped onto NS 35 DIN rails.
do not touch the terminal block.
Cover plate over the terminal block in metallised aluminium.
What are the proper using conditions and temperature for the Terminal Blocks?
The terminal block must not come loose or break off the rail.
Protection class IP64 due to optional available connector cap to the terminal block.
The terminal blocks are wired with the rated cross section.
Before and after the test, the terminal block must pass the voltage-drop test.
The terminal blocks used in rail vehicles must therefore be suitable for such use.
Operating elements• Place the terminal block on the pins inside the housing.
The terminal blocks utilize the advantages of the CLIPLINE complete system.
When replacing anTx-IXL061 with the Tx-IXL062 module, it's necessary to rewire the terminal block.
The terminal blocks from Phoenix Contact attain the classification I2/F2. Back to top.
This means that realistic accelerations are generated at the terminal block and the connected conductor.
Switching symbols on the terminal blocks also provide easy
The terminal blocks enable simple potential distribution via a function shaft on each level.
you need to ensure that the terminal blocks for the terminal boxes remain freely available,
Perform infrared temperature measurement on the terminal block of the microcomputer relay protection tester regularly,
Similar to the wired approach, multi-core cables from the field still come into the right side of the terminal blocks in the marshalling cabinet, so there are no changes to work done by technicians that wire up cables from the field.
Remove the screws from the terminal block to make contacts(if required by design).
Connects to balanced signal sources via the included terminal block.