Beispiele für die verwendung von Programming is done auf Englisch und deren übersetzungen ins Deutsch
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Ecclesiastic
-
Political
-
Computer
-
Programming
-
Official/political
-
Political
Programming is done via paddle.
CD& USB adaptor. Programming is done via interface.
Programming is done via push buttons on the device.
Without a master computer or PC, programming is done in MotionBasic.
The Programming is done using the TouchKey Programmer.
No configuration work is needed on site because all the programming is done centrally.
The programming is done without any cables in seconds!
The Kuhnke FIO Controller 113 can be individuallyextended with modules of the FIO I/O system, the programming is done with CODESYS V3.
Programming is done when AUTO INSTALL stops flashing.
No special training is needed, because the programming is done in the same development environment with Visual Studio®.
Programming is done in the programming language AHDL.
This software does not require strong knowledge of programming because the programming is done graphically using drag and drop of functional blocks.
Programming is done with the connected motor and the battery.
The forms can easily be created by the respective department, and automatic completion using data from datasources is also possible without the need for any programming: Programming is done once by creating a connector for a data source.
The programming is done by MCD programs using the integrated interpreter via a.
Laser programming is done according to data(IGES) in Toplas program.
Programming is done via the integrated electronic program guide EPG.
Further programming is done with the config block"Wallbox.
Programming is done via the device or by PC software USB interface.
Advanced programming is done on a PC, connected with the RS-232 link.
Programming is done through the RoboPlus software, included with the robot.
Advanced programming is done on a PC, connected with the RS-232 link.
Programming is done via the device or by PC software USB interface.
If no programming is done within a period, antifreeze function is active.
Programming is done with the attached drive motor and battery even if OPTO controllers.
The system programming is done with the KNX software ETS or LonMaker for a LonWorks system.
Programming is done very easily by the use of a graphical programming environment; hence programming skills are not required.
Programming is done by means of a telemetric connection of the HoTT system directly on the transmitter display(HoTT transmitter with voice telemetry output) or SMART-BOX for older HoTT transmitters.
Programming is done by means of the push buttons(see Operational description) In the programming mode, the status display will indicate the code of the parameter that is selected The value display indicates the value for the parameter.
The programming was done primarily in VHDL.