Примеры использования Does not light на Английском языке и их переводы на Русский язык
{-}
-
Official
-
Colloquial
Does not light at all- the notebook is off.
The problem is no more- the light does not light.
The burner does not light or the flame is not. .
Press the red button and the red light does not light.
LED does not light during charging/ Charging takes longer.
Люди также переводят
If the Router Link LED does not light, try again.
The burner does not light or the flame is not even around the burner.
It may cause a malfunction of the lamp does not light, etc.
If the Power LED does not light, press the Power On/Off button.
Adjust the position of unit in case the indicator does not light up.
If the pilot flame does not light or it goes out, repeat step.
Q1: How to deal with problem of there is no display, andafter you press the reset button, the indicator D1 does not light and with no backlit?
If the burner does not light within 15 seconds, wait for at least one minute.
Q2: When the screen just display squares, andthe the indicator D1 does not light after you press the reset button, How to deal with?
It does not light just by connecting the transmitter to an AC power source.
If the 2.4 GHz Link Rate LED does not light, or the LED is blinking amber, try again.
Lamp does not light: not connected to a DC power supply, or not to place the Qi wireless power receiving device;
Or, what woman having ten drachmas,if she lose one drachma, does not light a lamp and sweep the house and seek carefully till she find it?
If it does not light, test the power outlet with another electrical device, such as a lamp.
The batteries in the scale must also be replaced if the LED on the scale does not light after activating the vibration sensor 4 x 1.5 V AAA batteries.
If it still does not light, see Connect with Web Browser Setup on page 8.
One web camera installed in front of the prospect of Independence,of course, it does not light the entire territory of the prospectus, but captures one of the main areas.
If the burner does not light, close the valve, wait for the gas to disperse, and try again in a few minutes.
If another electrical device works when plugged into the power outlet, butthe Standby Indicator of the unit does not light when plugged into the same outlet, it indicates that the internal power fuse may have blown.
If the LED still does not light, follow the instructions for No WPS button on the right.
Adjust the[TRIM] control so that the orange indicator lights where the track's volume is highest(at the climax, etc.)Be careful that the red indicator does not light, or the sound could be distorted.
If the Status LED does not light, press the Power On/Off button on the extender.
Adjust the[MASTER LEVEL] control so that the orange indicator lights where the track's volume is highest(at the climax, etc.)Be careful that the red indicator does not light, or the sound could be distorted.
If the Power LED does not light, press the Power On/Off button on the extender.
When the status indicator(LED) does not light even though is pressed, change all batteries.